Checking the engine oil level
3. Reinsert the dipstick—push it in as far
as it will go, or the reading will not be
correct.
If the oil level is below or only slightly
above the low level, add engine oil of
the same type as already in the engine.
Low level
Full level
4. Pull the dipstick out and look at the oil
Remove the oil filler cap and add engine
oil in small quantities at a time, checking
the dipstick. We recommend that you use
a funnel when adding oil.
level while holding
end.
a
rag under the
82p001a
CAUTION
Add oil
O.K.
Too full
The approximate quantity of oil needed to
raise the level between low and full on the
dipstick is indicated as follows:
Be careful not to touch the hot ex-
haust manifold.
1.5 L (1.6 qt., 1.3 Imp.qt.)
For the engine oil capacity, see “Service
specifications” on page 427.
NOTICE
With the hybrid system at operating
temperature and turned off, check the
oil level on the dipstick.
When the level reaches within the correct
range, install the filler cap hand−tight.
Be careful not to drop engine oil on
the vehicle components.
1. To get a correct reading, the vehicle
should be on level ground. After turning
off the hybrid system, wait a few min-
utes for the oil to drain back into the
bottom of the engine.
2. Pull the dipstick out, hold the rag un-
der the end and wipe it clean.
400
English 