Before using
the multi−information display
Switch operation
When the “ACC” mode is enabled, the
initial screen appears and the system be-
gins operating.
This system operates mainly by the
switches on the screen. To protect the
screen, lightly touch switches on the
screen with your finger. When you touch
a switch on the screen or on the bezel,
a beep sounds.
After a few seconds, the previous mode
display will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will be automatically
set to the initial mode.
ꢀ If the system does not respond to a
27p178
touch of
a
switch, move your finger
away from the screen and then touch
it again.
ꢀ You cannot operate dimmed switches.
ꢀ Wipe off fingerprints on the surface of
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
the display using
a
glass cleaning
Type 1 and Type 2
cloth.
ꢀ The displayed image may become
darker and moving images may be
slightly distorted when the display is
cold.
ꢀ When you look at the screen through
polarized material such as polarized
sunglasses, the screen may be dark
26p049b
and hard to see.
If so, change the
angle of the screen or take off your
sunglasses.
Type 3
163
English 