Get Storage -> Load compartment Guide for Vauxhall Combo Van Fifth Generation (2018-2026)

72

Storage

The separation of the four

Underseat storage

Underseat drawer

compartments can be taken out.

The maximum permitted load is 6 kg.

9 Warning

Secure objects to prevent them

from falling out and causing injury.

Pull handle to open.

Close whilst driving. The maximum

permitted load is 10 kg.

There may be a drawer under the

front seats. To open lift the drawer a

bit and then pull.

Slide the flaps to open.

Close whilst driving. The maximum

permitted load is 10 kg.

Storage

73

Storage box

Centre console storage

Vehicle tools may be located in the

stowage compartments underneath

the front seats 3 230.

There may be a storage box under the

centre bench seat. Lift up the seat

cushion by pulling the handle. The

storage box can be locked by a

padlock.

A storage box may be located in the

centre console. Press cover to open.

A 12 V power outlet is located behind

the storage cover.

Footwell storage

The footwell storages can be

accessed from the rear seats.

74

Storage

Depending on version, there are two

stowage compartments in the rear

footwell.

Opening the ladder flap

Load compartment

Depending on version, the load

compartment area can be increased

by folding up or removing the third row

seats. The seat backrests of the

second row can be folded forward

separately. Additionally, the backrest

of the passenger seat can be folded.

Depending on the loading, only single

seats or backrests can be folded.

Folding passenger seat 3 47

Folding second row seats 3 50

Folding or removing third row seats

3 50

1. Press the lever and disengage the

spring clip from the retainer by

pulling.

2. Lift the ladder flap.

Ladder flap

The ladder flap is available for

transporting long loads.

Storage

75

Closing the ladder flap

1. Check that the support bar is

properly locked.

2. Lower the ladder flap.

3. Fix the spring clip in its retainer.

Load compartment cover

Rear luggage cover

Do not place any objects on the cover.

3. Move past the point of resistance

to lock the ladder flap with the

props.

1. Push the lever to the top.

Closing the cover

2. Push the support bar a bit to the

front and then guide it down to the

door pillar.

Support bar

Rest long loads on the support bar.

3. Hold the long load in the angled

position.

4. Move the support bar below the

load to its original position. Fix it

by pressing the lever downwards

past the point of resistance.

The rear doors will only lock when

the support bar is installed.

5. Secure the loads firmly. The side

supports can be used as hooking

points.

Pull the load compartment cover

towards the rear and engage it in the

side brackets.

76

Storage

Opening the cover

Removing the cover

Stowing in the load compartment

Remove load compartment cover

from side brackets. Guide the cover

until it is fully rolled up.

Open the load compartment cover.

If the load compartment cover is not

used, stow it in the load compartment.

It can be stowed behind the second or

third row seats.

Compress the load compartment

cover at one side and lift it up.

Remove the load compartment cover.

Fitting the cover

Insert the load compartment cover

into the recess at one side. Compress

the cover at the other side and

engage it in the recess.

Storage

77

Rear parcel shelf

Lifting the rear parcel shelf

Stowing in the load compartment

Do not place any excessively heavy

or sharp-edged objects on the rear

parcel shelf. The maximum load

permissible is 25 kg. With high loads

install the safety net behind the rear

seats 3 79.

Installing the rear parcel shelf

The rear parcel shelf may be folded

up from the rear, allowing greater

flexibility in the load compartment.

Set up the folded cover upright behind

the rear seat backrests.

The rear parcel shelf can be installed

in two positions.

Fit the parcel shelf by engaging in the

retainers on both sides.

78

Storage

Lashing eyes may be located on the

vehicle floor and / or in the sidewall.

The number and location of the

lashing eyes may vary depending on

the vehicle.

There may be a flap in the partition

behind the passenger seat which can

be removed to accommodate long

objects. A protective cover is

provided in the vehicle to assure safe

transportation.

Lashing eyes

If the outer passenger seat backrest

is folded down and the partition flap is

open, the centre seat has to stay free.

Removing the flap

The maximum force applied to the

lashing eyes should not exceed

500 daN / 5 kN / 5000 N.

Depending on country, the maximum

force may be shown on a label.

The lashing eyes are designed to

secure items against slippage, e.g.

using lashing straps or luggage net.

Notice

Specifications on the label always

have priority over those given in this

manual.

Cargo management system

Depending on version, a partition

behind the front seats protects the

driver and front passengers against

the risk of load movement.

1. Release the locking device, lower

the flap and then remove it.

2. Stow the flap behind the driver's

seat.

Storage

79

Turn the locking device upwards.

Put the hinges of the flap in their

housing, lift the flap and close the

locking device.

2. Attach the four snap hooks of the

cover on the corresponding

lashing eye.

3. Pull the head restraint from the

folded backrest, leaving two

notches visible on the head

restraint rod 3 44.

5. Pass the strap of the cover around

the head restraint. Tension the

strap by pulling at the loose end.

With fitted protective cover the

maximum load on the folded backrest

is 100 kg.

Fitting the protective cover

The protective cover must be

installed whenever the outer

4. Load the objects.

Safety net

passenger seat backrest is folded

down and the partition flap is open.

Depending on version, the safety net

can be installed behind the rear seats

or, if the rear seat backrests are

folded, behind the front seats.

1. Fold the outer passenger seat

backrest 3 47.

Passengers must not be transported

behind the safety net.

80

Storage

Behind the front seats

Installation

Behind the rear seats

●

Attach the hooks of safety net

straps in the lashing eyes behind

the rear seats.

Tension both straps by pulling at

the loose end.

Rear seat backrests must be

raised up.

●

There are installation openings

on both sides in the roof frame

above the front seats. Open the

covers and suspend and engage

rod of net at one side, compress

rod and suspend and engage at

the other side.

●

There are installation openings

on both sides in the roof frame

above the rear seats. Open the

covers and suspend and engage

rod of net at one side, compress

rod and suspend and engage at

the other side.

Storage

81

The partition can be placed behind

the front or rear seats.

Load compartment grille

●

Wind one strap around the bar

located under the front driver

seat cushion. The other one wind

around the bar of the passenger

seat. Then secure each hook to

the corresponding strap.

Tension both straps by pulling at

the loose end.

Push down head restraints and

fold down rear seat backrests

3 74.

Depending on version a partition

protects the driver and passengers

against the risk of load movement.

There is a flap in the partition which

can be opened to accommodate long

objects. A protective cover is

provided in the vehicle to assure safe

transportation.

If the side seat backrest is folded

down and the partition flap is open the

centre seat has to stay free.

If the backrest of the rear seat is

lowered and the flap open to transport

long objects, the front passenger seat

has to stay free.

82

Storage

Moving the partition

3. Move the partition and lock the

four locking devices on the top

and the bottom.

2. Release the locking device of the

flap and open the flap.

1. Release the four locking devices

on the top and the bottom of the

partition.

2. To be placed behind the front

seats fold down the rear seat

backrests 3 50

9 Warning

Take care when operating the

bottom locking devices. Risk of

pinching.

Opening the flap

1. Depending on the positioning of

the partition and the length of the

load fold down the outer rear seat

backrest and / or passenger seat

backrest 3 47, 50

3. Secure the flap with the rod.

Storage

83

Closing the flap

1. Fix the rod in the bracket.

1. Attach the four snap hooks of the

cover on the corresponding

lashing eye.

2. Pull the head restraint from the

folded backrest, leaving two

notches visible on the head

restraint rod 3 44.

4. Pass the strap of the cover around

the head restraint. Tension the

strap by pulling at the loose end.

2. Close the flap and lock the locking

device.

3. Restore the seats to the upright

position 3 47, 50

3. Load the objects.

Fitting the protective cover

The protective cover must be

installed whenever the side seat

backrest is folded down and the

partition flap is open.

If the loading is stored on the front

and rear seat at the passenger

84

Storage

side pass one strap on each head

restraint.

First aid kit

Roof rack system

With fitted protective cover the

maximum load on each of the folded

backrests is 100 kg.

Roof rack

For safety reasons and to avoid

damage to the roof, the vehicle

approved roof rack system is

recommended. For further

Warning triangle

information contact your workshop.

Follow the installation instructions

and remove the roof rack when not in

use.

Mounting roof rack

Depending on version, the first aid kit

can be stowed in the load

compartment.

Vehicles with roof railing

Depending on version, the warning

triangle can be stowed in the load

compartment. Secure it with the

elastic straps.

Storage -> Load compartment for Your Vauxhall Combo Van Fifth Generation (2018-2026)

Related Topics

Storage

Popular Owner Manuals

Latest Owner Manuals