Storage -> Roof rack system for Your Vauxhall Combo Van Fifth Generation (2018-2026)

84  
Storage  
side pass one strap on each head  
restraint.  
First aid kit  
Roof rack system  
With fitted protective cover the  
maximum load on each of the folded  
backrests is 100 kg.  
Roof rack  
For safety reasons and to avoid  
damage to the roof, the vehicle  
approved roof rack system is  
recommended. For further  
Warning triangle  
information contact your workshop.  
Follow the installation instructions  
and remove the roof rack when not in  
use.  
Mounting roof rack  
Depending on version, the first aid kit  
can be stowed in the load  
compartment.  
Vehicles with roof railing  
Depending on version, the warning  
triangle can be stowed in the load  
compartment. Secure it with the  
elastic straps.  
Storage  
85  
Mounting points are located at the  
bottom of the roof railing.  
Fasten the roof rack according to the  
installation instructions delivered with  
the roof rack.  
Do not place any objects on the  
rear luggage cover or the  
instrument panel, and do not  
cover the sensor on top of the  
instrument panel.  
The load must not obstruct the  
operation of the pedals, parking  
brake and gear selector, or  
hinder the freedom of movement  
of the driver. Do not place any  
unsecured objects in the interior.  
Loading information  
Vehicles without roof railing  
Do not drive with an open load  
compartment.  
9 Warning  
Heavy objects in the load  
compartment should be placed  
against the seat backrests. Make  
sure that the backrests are  
Always make sure that the load in  
the vehicle is securely stowed.  
Otherwise objects can be thrown  
around inside the vehicle and  
cause personal injury or damage  
to the load or car.  
securely engaged. If objects can  
be stacked, heavier objects  
should be placed at the bottom.  
Prevent sliding of loose objects  
by securing them with straps  
attached to the lashing eyes  
3 78.  
Do not allow the load to protrude  
above the upper edge of the  
backrests.  
To fasten a roof rack, unscrew the  
caps in the roof strips. Insert the  
mounting provisions, as instructed, in  
the retainer.  
The payload is the difference  
between the permitted gross  
vehicle weight (see identification  
plate 3 256) and the EC kerb  
weight.