Instruments and controls -> Controls for Your Vauxhall Crossland SUV First Generation (2020-2024)

70  
Instruments and controls  
Steering wheel controls  
Heated steering wheel  
Controls  
Steering wheel adjustment  
Cruise control and speed limiter are  
operated via the controls on the left  
side of the steering wheel.  
On the same side is located the  
switch for the heated steering wheel.  
Infotainment system can be operated  
via the controls on the right side of the  
steering wheel.  
Activate heating by pressing *.  
Activation is indicated by the LED in  
the button.  
Heating is operational when the  
engine is running and during an  
Autostop.  
Unlock lever, adjust steering wheel,  
then engage lever and ensure it is  
fully locked.  
Do not adjust steering wheel unless  
vehicle is stationary and steering  
wheel lock has been released.  
Stop-start system 3 126.  
Driver assistance systems 3 140.  
Further information is available in the  
Infotainment manual.  
Heated steering wheel 3 70.  
Instruments and controls  
71  
To activate interval wiping mode the  
next time ignition is switched on,  
press the lever downwards to position  
OFF and back to INT.  
Horn  
Windscreen wiper and  
washer  
Windscreen wiper with adjustable  
wiper interval  
Adjustable wiper interval  
Press j.  
HI : fast  
Wiper lever in position INT.  
Turn the adjuster wheel to adjust the  
wiping frequency.  
LO : slow  
INT : interval wiping  
OFF : off  
1x : single wipe  
Do not use if the windscreen is frozen.  
Switch off in car washes.  
72  
Instruments and controls  
switched on, press the lever  
downwards to position OFF and back  
to AUTO.  
Windscreen wiper with rain  
sensor  
Windscreen washer  
Do not use if the windscreen is frozen.  
Switch off in car washes.  
Adjustable sensitivity of the rain  
sensor  
Pull lever. Washer fluid is sprayed  
onto the windscreen and the wiper  
wipes a few times.  
HI  
: fast  
LO  
: slow  
AUTO : automatic wiping with rain  
Washer fluid 3 178.  
sensor  
OFF : off  
1x  
: single wipe  
Wiper lever in position AUTO.  
Turn the adjuster wheel to adjust the  
sensitivity of the rain sensor.  
Make sure the sensor is not blocked  
3 35, 3 10.  
Control indicator < 3 71.  
In AUTO position, the rain sensor  
detects the amount of water on the  
windscreen and automatically  
regulates the frequency of the  
windscreen wiper. If ignition is  
switched off, automatic wiping mode  
is deactivated. To activate automatic  
wiping mode the next time ignition is  
Instruments and controls  
73  
Activation or deactivation of this  
function can be changed in the  
Vehicle personalisation menu 3 96.  
Rear window wiper and  
washer  
Rear window wiper  
Outside temperature  
A drop in temperature is indicated  
immediately and a rise in temperature  
after a time delay.  
Rear window washer  
OFF : off  
Illustration shows an example.  
Push lever.  
INT : intermittent operation  
ON : continuous operation  
If outside temperature drops to 3 °C,  
a warning message is displayed in the  
Driver Information Centre.  
Washer fluid is sprayed onto the rear  
window and the wiper wipes a few  
times.  
The rear window washer system is  
deactivated when the fluid level is  
low.  
Do not use if the rear window is  
frozen.  
Switch off in car washes.  
The rear window wiper comes on  
automatically when the windscreen  
wiper is switched on and reverse gear  
is engaged.  
9 Warning  
The road surface may already be  
icy even though the display  
indicates a few degrees above 0  
°C.  
Washer fluid 3 178.  
74  
Instruments and controls  
Do not damage the outlets by using  
unsuitable plugs.  
Stop-start system 3 126.  
Clock  
Date and time are shown in the  
Info Display 3 91.  
Setting date and time, see  
Infotainment manual.  
USB charging port  
Power outlets  
Another power outlet is located in the  
console between the front seats.  
Do not exceed the maximum power  
consumption of 120 W.  
With ignition off, the power outlet is  
deactivated. Additionally, the power  
outlet is deactivated in the event of  
low vehicle battery voltage.  
Electrical accessories that are  
connected must comply with the  
electromagnetic compatibility  
requirements laid down in  
DIN VDE 40 839.  
One or two USB ports are prepared  
for charging devices.  
When two USB ports are available,  
the upper USB port can be used to  
connect a phone for phone projection.  
A 12 V power outlet is located in the  
centre console.  
Notice  
The sockets must always be kept  
clean and dry.  
Do not connect any current-delivering  
accessories, e.g. electrical charging  
devices or batteries.  
USB port and phone projection see  
Infotainment manual.  
Instruments and controls  
75  
On some mobile devices, a back  
cover with an integrated coil or a  
jacket may be required to use  
inductive charging.  
Inductive charging  
9 Warning  
Protective cover for the mobile device  
could have impact on the inductive  
charging.  
Inductive charging can affect the  
operation of implanted  
pacemakers or other medical  
devices. If applicable, seek  
medical advice before using the  
inductive charging device.  
LED illuminates yellow, when  
metall objects have been  
detected in the charging area  
mobile device was not placed  
9 Warning  
properly.  
To charge a mobile device:  
In the case that the mobile device is  
not charging properly:  
1. Remove the mobile device from  
1. Remove all objects from the  
Remove any metal objects from  
the charging device before  
charging a mobile device, as these  
objects could become very hot.  
charging device.  
2. Place the mobile device with the  
display facing upwards on the  
charging device.  
the charging device.  
2. Rotate the mobile device by 180°.  
3. Wait 3 seconds after the LED has  
extinguished and place the mobile  
device on the charging device  
again.  
3. LED illuminates green, when  
mobile device is charging.  
The mobile device must be smaller  
than 7 cm by 15 cm to fit into the  
charging device.  
PMA or Qi compatible mobile devices  
can be charged inductively.  
76  
Instruments and controls  
Cigarette lighter  
A portable ashtray can be placed in  
the cupholders.  
Press in the cigarette lighter. It  
switches off automatically once the  
element is glowing. Pull out the  
cigarette lighter.  
Ashtrays  
Caution  
To be used only for ash and not for  
combustible rubbish.