Seats, Restraints -> Child restraints for Your Vauxhall Frontera SUV Third Generation (2024-2026)

26  
Seats, Restraints  
Consult a workshop immediately if  
neither of the two control indicators are  
illuminated.  
Otherwise, there is a risk of fatal injury  
for a person occupying a seat with a  
deactivated front passenger airbag.  
Change status only when the vehicle is  
stopped with the ignition off.  
Control indicator for airbag deactivation  
ðpage48 .  
Child restraints  
Child Restraint Systems  
Danger  
Use the ignition key to choose the  
position:  
Make sure that children below sufficient  
size and weight are protected using a  
suitable child restraint system. Never  
place a child on the lap.  
OFF  
front passenger airbag is  
deactivated and will not inflate  
in the event of a collision.  
Control indicator illuminates  
continuously in the centre  
console  
If the control indicator ON illuminates for  
approx. 60 seconds after the ignition is  
switched on, the front passenger airbag  
system will inflate in the event of a  
collision.  
If the control indicator OFF illuminates  
after the ignition is switched on,  
the front passenger airbag system is  
deactivated. It stays on while the airbag  
is deactivated.  
If both control indicators are illuminated  
at the same time, there is a system  
failure. The status of the system is  
not discernible, therefore no person is  
allowed to occupy the front passenger  
seat. Contact a workshop immediately.  
Danger  
If using a rear-facing child restraint  
system on the front passenger seat, the  
airbag system for the front passenger  
seat must be deactivated. This also  
applies to certain forward-facing child  
restraint systems as indicated in the  
Child Restraints table.  
front passenger airbag is  
active  
ON  
Danger  
Deactivate the passenger airbag only  
in combination with the use of a  
child restraint system, subject to the  
instructions and restrictions in the Child  
Restraints table.  
Airbag deactivation ðpage25  
Airbag label ðpage22  
Seats, Restraints  
27  
We recommend a child restraint system  
that is tailored specifically to the vehicle.  
For further information, contact your  
workshop.  
Child restraint systems can be fastened  
with:  
ISOFIX brackets are indicated by a label  
on the backrest. To get access to the  
ISOFIX brackets, first pull the zip.  
An i-Size child restraint system is an  
universal ISOFIX child restraint system  
according to UN Regulation No. 129.  
All i-Size child restraint systems can be  
used on any vehicle seat suitable for  
i-Size, child restraint installation table  
ðpage30 .  
When fastening ISOFIX child restraint  
systems on adjustable passenger seats,  
first incline the backrest as far as  
necessary backwards in order to get  
access to the ISOFIX brackets.  
After the proper fastening of the  
ISOFIX child restraint system, incline the  
backrest forward again.  
Three-point seat belt  
ISOFIX brackets  
Top-tether anchors  
In case of any interference of the child  
restraint system with the vehicle seat  
head restraint, adjust or remove the  
corresponding head restraint ðpage16 .  
When a child restraint system is being  
used, pay attention to the following usage  
and installation instructions and also  
those supplied with the child restraint  
system. The given restrictions in the  
table refer to a test body, which is the  
maximum envelope of all existing child  
restraint systems. Make sure that the  
front seats do not interfere with the used  
child restraint system.  
Three-point seat belt  
Child restraint systems can be fastened  
by using a three-point seat belt. After  
fastening the child restraint system the  
seat belt must be tightened ðpage30 .  
"ISOFIX" Brackets  
Always comply with local or national  
regulations. In some countries, the use  
of child restraint systems is forbidden on  
certain seats.  
Only drive with the driver seat correctly  
adjusted ðpage17 .  
Either a top-tether strap or a support leg  
must be used in addition to the ISOFIX  
brackets.  
i-Size child seats and vehicle seats with  
i-Size approval are marked with i-Size  
symbol, see illustration.  
Danger  
Extreme Hazard!  
Do not use a rearward facing child  
restraint on a seat protected by an  
airbag in front of it.  
Fasten vehicle-approved ISOFIX child  
restraint systems to the ISOFIX brackets.  
Specific vehicle ISOFIX child restraint  
system positions are marked in the child  
restraints table.  
28  
Seats, Restraints  
Do not use forward facing child restraint  
system at all seats when child's weight is  
below 13 kg or child's size is less than 76  
cm and up to the age of 15 months.  
Suitable are child restraint systems that  
comply with valid UN ECE regulations.  
Check local laws and regulations for  
mandatory use of child restraint systems.  
The following child restraints are  
recommended for the following weight  
classes:  
Bought in Stellantis & You, Sales and  
Services.  
Top-tether anchors  
We recommend using the child seat  
with the backrest.  
If the backrest is removed for a child  
over 138 cm, the secure guard must  
also be removed.  
Ensure that the child restraint system to  
be installed is compatible with the vehicle  
type.  
Child seat at the front: Adjust the  
front passenger seat to the highest and  
fully back longitudinal position with the  
backrest straightened.  
Child seat at the rear: Move the vehicle's  
front seat forward and straighten the  
backrest so that the legs of the child in  
the forward facing or the rearward facing  
child seat do not touch the vehicle's front  
seat.  
In case of any interference of the  
child restraint system with the vehicle  
seat head rest, adjust or remove the  
corresponding vehicle seat head rest.  
Please follow the child restraint  
manufacturer’s instructions to install the  
corresponding child restraints in the  
vehicle.  
Römer Baby-Safe 3 i-Size  
Size: 40 - 83 cm  
Age: from birth to 15 months  
Weight: up to 13 kg  
Recommended with its ISOFIX base.  
Suitable for rearward facing installation  
only.  
Top-tether anchors are marked with a  
symbol for child seat.  
In addition to the ISOFIX brackets, fasten  
the top-tether strap to the top-tether  
anchors.  
ISOFIX child restraint systems of  
universal category positions are marked  
in the table. ðpage30  
RömerTriFix 2 i-Size  
Size: 76 - 105 cm  
Age: from 15 months to 4 years  
Weight: from 9 to 22 kg  
Installed with ISOFIX and Top-tether  
mountings.  
Suitable for forward facing installation  
only.  
Selecting The Right System  
The rear seats are the most convenient  
location to fasten a child restraint system.  
Children should travel facing rearwards  
in the vehicle as long as possible. This  
makes sure that the child's backbone,  
which is still very weak, is under less  
strain in the event of an accident.  
Römer Kidfix i-Size  
Size: 100 - 150 cm  
For semi-universal or vehicle specific  
child restraint system (ISOFIX or belted  
child restraint system), see the vehicle  
list provided in the user manual of the  
child restraint system.  
Age: from 3.5 to 12 years  
Weight: from 15 to 36 kg  
with or without ISOFIX mountings  
The child is restrained by the seat belt.  
Seats, Restraints  
29  
Ensure that the mounting location of the  
child restraint system within the vehicle is  
correct, see following table.  
Allow children to enter and exit the  
vehicle only on the side facing away from  
the traffic.  
When the child restraint system is not in  
use, secure the seat with a seat belt or  
remove it from the vehicle.  
Note  
Do not affix anything on the child restraint  
systems and do not cover them with any  
other materials. A child restraint system  
that has been subjected to stress in an  
accident must be replaced.