Get Climate control Guide for Vauxhall Grandland SUV Second Generation (2025-2026)

Climate control

161

●

automatic mode AUTO

temperature on front passenger

side £

cooling A/C

manual air recirculation 4

demisting and defrosting à

heated rear window and exterior

mirrors b

Climate control systems

Climate control

Electronic climate control

system

●

Climate control systems ............. 161

Electronic climate control

system .................................... 161

Auxiliary heater ........................ 167

Temperature preconditioning . . 167

Air vents ..................................... 168

Adjustable air vents ................. 168

Fixed air vents ......................... 169

Maintenance .............................. 169

Air intake ................................. 169

Air conditioning regular

operation ................................ 170

Service .................................... 170

The dual zone climate control allows

different temperatures for driver side

and front passenger side.

In automatic mode, temperature, fan

speed and air distribution are

regulated automatically.

●

heated windscreen ,

heated seats ß

ventilated seats A

Heated rear window Ü 3 27.

Heated exterior mirrors Ü 3 24.

Heated seats ß 3 35.

Ventilated seats A 3 35.

Activated functions are indicated by

the LED in the respective control.

The electronic climate control system

is only fully operational when the

engine is running.

Make sure the sun sensor on top of

the instrument panel used by the

electronic climate control system is

not covered.

Controls for:

●

temperature on driver side £

MENU enters the climate control

settings menu in the Info Display

●

fan speed Z

162

Climate control

●

Open all air vents to allow

optimised air distribution in

automatic mode.

Climate control settings menu

Climate setting menu can be

displayed in the Info Display.

Automatic mode AUTO

Air conditioning must be

Info Display 3 161.

activated for optimal cooling and

demisting. Press A/C to switch on

air conditioning. The LED in the

button indicates activation.

Basic setting for maximum comfort:

●

Set the preselected

temperatures for driver and front

passenger using the left and right

rotary knob. Recommended

temperature is 22 °C.

●

air distribution l, M, K

fan speed Z

temperature for driver and

passenger side

dual zone temperature

synchronisation MONO

cooling A/C

automatic mode AUTO

maximum air conditioning AC/

MAX

●

Press AUTO, the air distribution

and fan speed are regulated

automatically.

Different pre-set fan speeds can be

set by turning the rotary knob.

Turn anticlockwise to decrease or

turn clockwise to increase the fan

speed.

●

Climate control

163

Temperature preselection £

To display the respective pre-set

speed, first press MENU to enter the

climate control settings menu and

then touch OPTIONS on the Info

Display.

Following speeds are selectable via

the rotary knob:

●

one bar for a soft and silent air

distribution.

two bars for thermal comfort and

silent air distribution.

three bars for a dynamic and

efficient air distribution.

Set the preselected temperatures

separately for the driver and the front

passenger to the desired value using

the left and right rotary knob. The

rotary knob on the passenger side

changes the temperature of the

passenger side. The rotary knob on

the driver's side changes the

temperature of the driver's side or of

both sides, depending on activation of

synchronisation MONO in the climate

control settings menu. Press MENU

to enter the climate control settings

menu.

164

Climate control

Recommended temperature is 22 °C.

Temperature is indicated in displays

beside the rotary knob and in the

climate settings menu.

Fan speed Z

Air distribution l, M, K

If the minimum temperature Lo is set,

the climate control system runs at

maximum cooling, if cooling A/C is

switched on.

If the maximum temperature Hi is set,

the climate control system runs at

maximum heating.

Note

If A/C is switched on, reducing the

set cabin temperature can cause the

engine to restart from an Autostop or

inhibit an Autostop.

Adjust the air flow by turning rotary

knob to the desired speed. Turn

anticlockwise to decrease or turn

clockwise to increase. Fan speed can

also be changed in the climate control

settings menu. Press MENU to enter

the climate control settings menu.

Turn rotary knob anticlockwise as far

as it will go: fan and cooling are

switched off.

Press MENU to enter the climate

control settings menu.

Touch on the Info Display:

Stop-start system 3 176.

: to windscreen and front door

l

windows

Manual settings

Climate control system settings can

be changed by activating the

following functions:

M : to head area and rear seats via

adjustable air vents

K : to front and rear foot well and

windscreen

To return to automatic air distribution,

press AUTO.

To return to automatic mode, press

AUTO.

Climate control

165

Dual zone temperature

Air conditioning A/C

Maximum air conditioning AC/MAX

Press MENU to enter the climate

control settings menu.

Touch A/C MAX to activate/

deactivate maximum air conditioning.

The maximum air conditioning

function sets the temperature as low

as possible and adjusts the

distribution to all air vents. In addition,

it sets the air flow to maximum and

activates the air recirculation.

synchronisation MONO or SYNC

Press MENU to enter the climate

control settings menu.

Touch OPTIONS to open the climate

options menu.

Manual air recirculation 4

Press A/C to switch on cooling. The

LED in the button illuminates to

indicate activation. Cooling is only

functional when the engine is running

and climate control fan is switched on.

Press A/C again to switch off cooling.

Set D to ON to link passenger side

temperature setting to the driver side

The air conditioning system cools and

dehumidifies (dries) when outside

temperature is above a specific level.

Therefore condensation may form

and drip from under the vehicle.

If no cooling or drying is required,

switch off the cooling system for fuel

saving reasons.

Touch MONO or SYNC to link

passenger side temperature setting

to the driver side.

When passenger side control dial will

be adjusted, synchronisation is

deactivated.

166

Climate control

Press 4 to activate the air

recirculation mode. The LED in the

button illuminates to indicate

activation.

Demisting and defrosting the

windows à

Note

If à is pressed while the engine is

running, an Autostop will be inhibited

until à is pressed again.

Press 4 again to deactivate

If à is pressed while the engine is in

an Autostop, the engine will restart

automatically.

recirculation mode.

9 Warning

Stop-start system 3 176.

The exchange of fresh air is

reduced in air recirculation mode.

In operation without cooling, the

air humidity increases, so the

windows may mist up from inside.

The quality of the passenger

compartment air deteriorates,

which may cause the occupants to

feel drowsy.

Deactivation of electronic climate

control system

Cooling, fan and automatic mode can

be switched off by turning the rotary

knob around the AUTO button

anticlockwise.

Activation by switching on the fan or

pressing AUTO.

Heated rear window, windscreen and

exterior mirrors b 3 27.

●

Press à. The LED in the button

illuminates to indicate activation.

Temperature and air distribution

are set automatically and the fan

runs at high speed.

Switch on air conditioning by

pressing A/C, if required.

Switch on heated rear window b.

Switch on heated

windscreen ,.

In warm and very humid ambient air

conditions, the windscreen may mist

up from outside, when cold air is

directed towards it. If windscreen

mists up from outside, activate

Heated seats ß 3 35.

●

windscreen wiper and deactivate l.

●

To return to previous mode,

press à again. To return to

automatic mode, press AUTO.

Climate control

167

Note

Auxiliary heater

The temperature preconditioning is

only activated if the ignition is off and

the vehicle is locked.

If the charging level of the high

voltage battery is below 30%, the

temperature preconditioning is not

activated.

Air heater

Quickheat is an electric auxiliary air

heater which automatically warms up

the passenger compartment more

quickly.

When the vehicle is plugged in,

battery charging takes precedence

over pre-conditioning.

Temperature

preconditioning

Consequently, it can only be

activated if the battery is charged

above a threshold fixed at 80%.

The temperature preconditioning

allows to heat or to ventilate the

vehicle's interior with ambient air.

The temperature preconditioning can

be programmed via the Info Display

or the MyOpel App.

The operating status of the

temperature preconditioning is shown

by a LED.

If a recurrent heating / ventilation is

programmed and two heating /

ventilation procedures are carried

out without operating the vehicle, the

programming is deactivated.

●

LED illuminates: A timer has

been set.

●

LED flashes: The system is

operating.

Setting timer

Note

The LED is extinguished at the end of

the operation or when the

temperature preconditioning is

stopped using the remote control.

The temperature preconditioning can

be programmed by using the Info

Display.

Several timers can be programmed

and saved. It is recommended to

programme temperature

preconditioning with the vehicle

plugged in, in order to optimise the

long-term perfomance of the high

voltage battery.

168

Climate control

Touch --:--.

Enter time and day.

Air vents

Adjustable air vents

Air vents in the instrument panel

Press A to confirm the settings.

Press ON to activate the timer.

To delete a timer, press f at the top

of the Info Display and delete the

desired timer.

Confirm the deletion.

The heating / ventilation procedure

starts approx. 45 minutes before the

programmed time when the vehicle is

plugged in, or 20 minutes before the

programmed time when it is not

plugged in, and is maintained ten

minutes after it.

Press MENU .

Touch OPTIONS.

Direct the flow of air by tilting and

swivelling the slats.

To close the vent, swivel the slats

inwards.

Select E.

Touch + to define a new timer.

Climate control

169

Outer air vents in the instrument

panel

Rear air vents in the centre

console

Direct the flow of air by tilting and

swivelling the slats.

Maintenance

Air intake

Fixed air vents

Additional air vents are located

beneath the windscreen and door

windows and in the foot wells.

Direct the flow of air by tilting and

swivelling the slats.

To close the vent, swivel the slats

outwards.

At least two air vents must be open

while cooling is on.

The air intake in front of the

windscreen in the engine

compartment must be kept clear to

allow air intake. Remove any leaves,

dirt or snow.

9 Warning

Do not attach any objects to the

slats of the air vents. Risk of

damage and injury in case of an

accident.

170

Climate control

Air conditioning regular

operation

In order to ensure continuously

efficient performance, cooling must

be operated for a few minutes once a

month, irrespective of the weather

and time of year. Operation with

cooling is not possible when the

outside temperature is too low.

Service

For optimal cooling performance, it is

recommended to annually check the

climate control system, starting

three years after initial vehicle

registration, including:

●

functionality and pressure test

heating functionality

leakage check

check of drive belts

cleaning of condenser and

evaporator drainage

●

performance check

Climate control for Your Vauxhall Grandland SUV Second Generation (2025-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals