Instruments and controls -> Controls for Your Vauxhall Grandland SUV Second Generation (2025-2026)

66  
Instruments and controls  
Steering wheel controls  
Heated steering wheel  
Controls  
Steering wheel adjustment  
Some driver assistance systems,  
Infotainment system and a connected  
mobile phone can be operated via the  
controls on the steering wheel.  
Activate heating by pressing *.  
Activation is indicated by the LED in  
the button.  
The heating works only when the  
outside temperature is below 20 °C.  
Heating is operational when the  
engine is running and during an  
Autostop.  
Unlock lever, adjust steering wheel,  
then engage lever and ensure it is  
fully locked.  
Do not adjust steering wheel unless  
vehicle is stationary and, depending  
on version, the steering wheel lock  
has been released.  
Further information is available in the  
Infotainment system section.  
Cruise control 3 205.  
Speed limiter 3 207.  
Adaptive cruise control 3 209.  
Stop-start system 3 176.  
 
Instruments and controls  
67  
To activate interval wiping mode the  
next time ignition is switched on,  
press the lever downwards to position  
OFF and back to INT.  
Horn  
Windscreen wiper and  
washer  
Windscreen wiper with adjustable  
wiper frequency  
Adjustable wiper frequency  
Press j.  
Pedestrian safety alert  
The sound of the pedestrian safety  
alert is generated to indicate the  
vehicle presence to pedestrians when  
combustion engine is off. It is active  
up to 20 km/h.  
HI : fast  
Wiper lever in position INT.  
Turn the adjuster wheel to adjust the  
desired wipe frequency.  
LO : slow  
INT : interval wiping  
OFF : off  
For a single wipe when the  
windscreen wiper is off, press the  
lever down to position 1x.  
Do not use if the windscreen is frozen.  
Switch off in car washes.  
 
68  
Instruments and controls  
Windscreen wiper with rain sensor  
switched on, press the lever  
downwards to position OFF and back  
to AUTO.  
Windscreen washer  
For a single wipe when the  
windscreen wiper is off, press the  
lever downwards to position 1x.  
Do not use if the windscreen is frozen.  
Switch off in car washes.  
Adjustable sensitivity of the rain  
sensor  
HI  
: fast  
Pull lever. Washer fluid is sprayed  
onto the windscreen and the wiper  
wipes a few times.  
LO  
: slow  
AUTO : automatic wiping with rain  
sensor  
Washer fluid 3 270.  
OFF : off  
In AUTO position, the rain sensor  
detects the amount of water on the  
windscreen and automatically  
regulates the frequency of the  
windscreen wiper. If ignition is  
switched off, automatic wiping mode  
is deactivated. To activate automatic  
wiping mode the next time ignition is  
Turn the adjuster wheel to adjust the  
sensitivity of the rain sensor.  
Make sure the sensor is not blocked  
3 25.  
Control indicator < 3 67.  
 
Instruments and controls  
69  
Activation or deactivation of this  
function can be changed in the Info  
Display 3 87.  
Rear window wiper and  
washer  
Rear window wiper  
Outside temperature  
A drop in temperature is indicated  
immediately and a rise in temperature  
after a time delay.  
Rear window washer  
OFF : off  
Illustration shows an example.  
Push lever.  
INT : intermittent operation  
ON : continuous operation  
If outside temperature drops to 3 °C,  
a warning message is displayed in the  
Driver Information Centre.  
Washer fluid is sprayed onto the rear  
window and the wiper wipes a few  
times.  
The rear window washer system is  
deactivated when the fluid level is  
low.  
Do not use if the rear window is  
frozen.  
Switch off in car washes.  
The rear window wiper comes on  
automatically when the windscreen  
wiper is switched on and reverse gear  
is engaged.  
9 Warning  
The road surface may already be  
icy even though the display  
indicates a few degrees above  
0 °C.  
Washer fluid 3 270.  
 
70  
Instruments and controls  
At the left sidewall in the load  
compartment, another 12 V power  
outlet is located.  
Do not exceed the maximum power  
consumption of 120 W.  
Clock  
Date and time are shown in the Info  
Display.  
The adjustment of date and time is  
described in the Infotainment system  
section.  
Info Display 3 87.  
Power outlets  
A 12 V power outlet is also located in  
the rear console.  
A 230 V power outlet may also be  
located in the rear console.  
Do not exceed the maximum power  
consumption of 150 W.  
With ignition off, the power outlets are  
deactivated. Additionally the power  
outlets are deactivated in the event of  
low vehicle battery voltage.  
A 12 V power outlet is located behind  
the storage cover. Press cover to  
open.  
 
Instruments and controls  
Inductive charging  
9 Warning  
71  
Electrical accessories that are  
connected must comply with the  
electromagnetic compatibility  
requirements laid down in  
DIN VDE 40 839.  
Do not connect any current-delivering  
accessories, e.g. electrical charging  
devices or batteries.  
Inductive charging can affect the  
operation of implanted  
pacemakers or other medical  
devices. If applicable, seek  
medical advice before using the  
inductive charging device.  
Do not damage the outlet by using  
unsuitable plugs.  
Stop-start system 3 176.  
9 Warning  
A further USB port may be located in  
the rear console.  
USB ports  
Remove any metal objects from  
the charging device before  
charging a mobile device, as these  
objects could become very hot.  
The USB ports are prepared for  
charging external devices and  
provide a data connection to the  
Infotainment system. For further  
information, see Infotainment system  
section.  
Note  
The sockets must always be kept  
clean and dry.  
A USB port is located behind the  
storage cover. Press cover to open.  
 
72  
Instruments and controls  
On some mobile devices, a back  
cover with an integrated coil or a  
jacket may be required to use  
inductive charging.  
Press in cigarette lighter. It switches  
off automatically once the element is  
glowing. Pull out cigarette lighter.  
Protective cover for the mobile device  
could have impact on the inductive  
charging.  
In the event that the mobile device is  
not charging properly, rotate it 180°  
and place it on the charging device  
again.  
Ashtrays  
Caution  
To be used only for ash and not for  
combustible rubbish.  
To charge a device, the ignition must  
be switched on.  
Cigarette lighter  
To charge a mobile device:  
1. Remove all objects from the  
charging device.  
2. Place the mobile device with the  
display facing upwards on the  
charging device in the storage.  
Use the elastic band to secure the  
mobile device.  
Charging status is indicated in the  
LED: illuminates green, when mobile  
device is charging.  
A portable ashtray can be placed in  
the cupholders.  
PMA or Qi compatible mobile devices  
can be charged inductively.  
The cigarette lighter is located behind  
the storage cover. Press cover to  
open.