Keys, Doors, Windows
29
Fault
Key with fixed blade,
see Fig. 15331 T on previous page.
If the central locking system cannot be
operated with the remote control, itmaybe
due to the following:
Have the workshop change the battery.
In the event of a functionality problem or
battery replacement, synchronise the
remote control.
z The range of the remote control has
been exceeded.
z Remote control battery voltage is too
low. Battery replacement - see next
column.
After changing the battery, unlock the
door using the key in the driver’s lock
cylinder, see page 32.The remote control is
synchronised by inserting the key in the
starter switch.
z If the remote control is frequently and
repeatedly operated outside the
reception range of the vehicle (e.g. too
far from vehicle), the remote control will
no longer be recognised. Remote control
synchronisation, see end column.
Picture no: 15332t.tif
Remote control battery replacement
Replace the battery as soon as the range
of the remote control becomes reduced.
z If the central locking system is
overloaded as a result of repeated
operation at short intervals. The power
supply is cut off for a brief period.
Ke y with re trac ta ble k ey blade ,
see Fig. 15330 T on previous page.
Extend key, see page 26. Open remote
control. Replace battery -battery type, see
page 218 - noting installation position.
Close remote control.
z Interference from higher-power radio
waves from other sources.
To eliminate the cause of a fault, we
recommend contacting a workshop for
assistance.
Make sure that you dispose of old batteries
in accordance with environmental
protection regulations.
Open driver’s door with key, see pa ge 32.
English 
