Lighting -> Exterior lighting for Your Vauxhall Vivaro Van Third Generation (2019-2026)

134  
Lighting  
Entry lighting ............................ 141  
Exit lighting .............................. 141  
Vehicle locator lighting ............ 142  
Peripheral lighting .................... 142  
Battery discharge protection .... 142  
Exterior lighting  
Light switch  
Lighting  
Exterior lighting .......................... 134  
Light switch .............................. 134  
Automatic light control ............. 135  
High beam ............................... 135  
High beam assist ..................... 135  
Headlight flash ......................... 136  
Headlight range adjustment .... 136  
Headlights when driving  
abroad .................................... 137  
Daytime running lights ............. 137  
Cornering lights ....................... 137  
Hazard warning flashers .......... 137  
Turn lights ................................ 138  
Front fog lights ......................... 138  
Rear fog light ........................... 138  
Reversing lights ....................... 139  
Misted light covers ................... 139  
Interior lighting ........................... 139  
Instrument panel illumination  
control ..................................... 139  
Interior lights ............................ 139  
Reading lights .......................... 140  
Sunvisor lights ......................... 141  
Turn light switch:  
AUTO : automatic light control  
switches automatically  
between daytime running  
light and headlight  
F
D
: sidelights  
: headlight  
When switching on the ignition,  
automatic light control is active.  
Control indicator F 3 116.  
Lighting features ........................ 141  
Centre console lighting ............ 141  
Lighting  
135  
high beam assist remains active and  
switches high beam on and off  
Tail lights  
Tail lights are illuminated together  
with low / high beam and sidelights.  
Automatic headlight activation  
During poor lighting conditions the  
headlights are switched on.  
Additionally, headlights are switched  
on if the windscreen wipers have  
been activated for several wipes.  
automatically. The latest setting of the  
high beam assist will remain after the  
ignition is switched on again.  
Automatic light control  
This feature automatically activates  
the high beam at night when vehicle  
is faster than 15 mph.  
High beam  
It switches automatically back to low  
beam when:  
A sensor detects the lights of  
oncoming or preceding vehicles.  
Driving in urban areas.  
The vehicle is slower than  
9 mph.  
It is foggy or snowy.  
Front or rear fog lights are  
switched on.  
When the automatic light control  
function is switched on and the  
engine is running, the system  
switches between daytime running  
lights and headlights automatically  
depending on the external lighting  
conditions and information given by  
the wiper system.  
If there are no restrictions detected,  
the system switches back to high  
beam.  
To activate the high beam, pull the  
lever beyond the resistance point.  
High beam assist  
The camera in the windscreen  
detects the lights of oncoming or  
preceding vehicles. Once activated,  
Daytime running light 3 137.  
136  
Lighting  
Activation  
Deactivation  
Headlight range adjustment  
Manual headlight range  
adjustment  
Depending on version the high beam  
assist can be deactivated by pressing  
B once or in the vehicle  
personalisation 3 127.  
With high beam on, pull the indicator  
lever once to deactivate high beam  
assist.  
Headlight flash  
Depending on version the high beam  
assist can be activated by pressing  
B once or in the vehicle  
personalisation 3 127.  
To adapt headlight range to the  
vehicle load to prevent dazzling: turn  
thumb wheel X to required position.  
The green control indicator B  
illuminates continuously when the  
assist is activated, the blue one C  
illuminates when high beam is on.  
0 : front seats occupied  
1 : up to five people or partial load  
2 : all seats occupied or driver and  
intermediate load  
Control indicator B 3 116.  
To activate the headlight flash, pull  
lever.  
3 : driver and permissible max. load  
Pulling lever deactivates high beam.  
Lighting  
137  
Headlights when driving  
abroad  
Cornering lights  
Hazard warning flashers  
When driving in countries where  
traffic drives on the opposite side of  
the road, the headlights must be  
adjusted to avoid dazzling oncoming  
drivers.  
Contact your dealer or a qualified  
Activated at a speed of up to 25 mph  
when turning off. Depending on the  
steering angle or the activation of the  
turn lights the front fog light illuminate  
the direction of travel.  
This function can be activated or  
deactivated in the vehicle  
personalisation 3 127.  
workshop.  
Daytime running lights  
Daytime running lights increase  
visibility of the vehicle during daylight.  
Operated by pressing ç.  
They are switched on automatically  
when the engine is running or by  
adjusting 0 or AUTO.  
Hazard warning flashers are switched  
on automatically in the following  
situations:  
The system switches between  
daytime running lights and low beam  
automatically, depending on the  
lighting conditions.  
Braking in an emergency  
(depending on the force of  
deceleration).  
In the event of an accident.  
They are switched off the first time  
you accelerate or if you press ç.  
138  
Lighting  
Turn lights  
Front fog lights  
Rear fog light  
up  
: right turn lights  
Turn the control wheel once to  
activate or deactivate the front fog  
light.  
Light switch in position AUTO:  
switching on front fog lights will switch  
headlights on automatically.  
Turn the control wheel once to  
activate or deactivate the rear fog  
light.  
down : left turn lights  
A resistance point can be felt when  
moving the indicator lever.  
Constant flashing is activated when  
the indicator lever is being moved  
beyond the resistance point. It is  
deactivated when the steering wheel  
is moved in the opposite direction or  
indicator lever is manually moved  
back to its neutral position.  
To activate three flashes, tap the  
indicator lever briefly without passing  
the resistance point.  
Lighting  
139  
Turn the control wheel twice to  
activate or deactivate the rear fog  
light.  
Light switch in position AUTO:  
switching on rear fog light will switch  
headlights on automatically.  
Interior lights  
Interior lighting  
Instrument panel  
illumination control  
During entry and exit of the vehicle,  
the front and rear courtesy lights  
automatically switch on and then off  
after a delay.  
Front and rear courtesy light  
Reversing lights  
The reversing light comes on when  
the ignition is on and reverse gear is  
selected.  
Misted light covers  
The inside of the light housing may  
mist up briefly in poor, wet and cold  
weather conditions, in heavy rain or  
after washing. The mist disappears  
quickly by itself. To help, switch on the  
headlights.  
Brightness can be adjusted when the  
exterior lights are on.  
Depending on version the brightness  
can be set by pressing and holding  
0 or ß until the desired  
brightness is obtained or in the  
vehicle personalisation 3 127.  
Operate rocker switch:  
;
: automatic switching on  
and off  
press § : on  
press 2 : off