Get Your driving environment -> Seats Guide for Volvo Xc70 SUV Third Generation (2025-2026)

03 Your driving environment

Seats

* Option/accessory, for more information, see Introduction.

Front seats

Lumbar support adjustment, turn the

wheel

Forward/backward: lift the handle to adjust

the distance to the steering wheel and ped-

als. Check that the seat is locked after

changing position.

Raise/lower* front edge of seat cushion,

pump up/down.

Adjust backrest rake, turn the wheel.

Raise/lower the seat, pump up/down.

Control panel for power seat*.

WARNING

Adjust the position of the driver's seat

before setting off, never while driving. Make

sure that the seat is in locked position in

order to avoid personal injury in the event of

sudden braking or an accident.

Lowering the front seat backrest

The passenger seat backrest can be folded

forward to make room for long loads.

Move the seat as far back/down as possi-

ble.

Adjust the backrest to an upright position.

Lift the catches on the rear of the backrest

and fold it forward.

4. Push the seat forward so that the head

restraint "locks" in under the glovebox.

Raising takes place in reverse order.

WARNING

Grasp the backrest and make sure that it is

properly locked after being folded up in

order to avoid personal injury in the event of

sudden braking or an accident.

Also applies to power seat.

03 Your driving environment

Seats

* Option/accessory, for more information, see Introduction.

Power seat*

Front edge of seat cushion up/down

Seat forward/backward and up/down

Backrest rake

The power front seats have overload protection

which is tripped if a seat is blocked by an

object. If this happens, go to key position I or

0 and wait a short time before adjusting the

seat again.

Only one movement (forward/back/up/down)

can be made at a time.

Preparations

The seats can be adjusted for a certain time

after unlocking the door with the remote con-

trol key without the key in the ignition switch.

Seat adjustment is normally made in key posi-

tion I and can always be made when the engine

is running.

Seat with memory function*

Store setting

Memory button

Button for storing settings

1. Adjust the seat and the door mirrors.

2. Hold the button depressed to store set-

tings while depressing one of the memory

buttons.

Using a stored setting

Hold one of the memory buttons depressed

until the seat and the door mirrors stop. If you

release the button then the movement of the

seat will stop.

Key memory* in remote control key

The positions of the driver's seat and the door

mirrors

are stored in the key memory when the

car is locked with the remote control key.

When the car is unlocked with the same remote

control key it was locked with and the driver's

For key memory for keyless drive, see page 56.

Only if the car is equipped with power seat with memory and retractable power door mirrors.

03 Your driving environment

Seats

* Option/accessory, for more information, see Introduction.

door is opened, the driver's seat and also the

door mirrors automatically adopt the positions

stored in the key memory.

NOTE

The seat and the door mirrors do not move

if they are already set the relevant position.

It is also possible to use the key memory by

pressing the unlock button on the remote con-

trol key when the driver's door is open.

The key memory can be activated/deactivated

in the menu system MY CAR under

Settings

Car settings Car key memory. For a

description of the menu system, see

page 146.

NOTE

In order that the key memory for the driver's

seat, and rearview and door mirrors, should

work with several remote control keys, the

key memory must be activated for each one

of the remote control keys.

Each one of the remote control keys must

be inserted into the ignition switch when the

key memory is activated for each respective

remote control key.

NOTE

The key memory in the remote control keys

and the seat's three memories are com-

pletely independent of each other.

Emergency stop

If the seat accidentally begins to move, press

one of the setting buttons for the seat or mem-

ory buttons in order to stop the seat.

Restarting to reach the seat position stored in

the key memory is performed by pressing the

unlock button on the remote control key. The

driver's door must then be open.

WARNING

Risk of crushing! Make sure that children do

not play with the controls. Check that there

are no objects in front of, behind or under

the seat during adjustment. Ensure that

none of the backseat passengers will be

trapped.

Heated/ventilated seats*

For heated/ventilated seats, see page 159.

Rear seats

Head restraint, centre seat, rear

Adjust the head restraint according to passen-

ger height so that the whole of the back of the

head is covered if possible. Slide it up as

required.

To lower the head restraint again, the button

(located in the centre between the backrest

and head restraint, see illustration) must be

pressed in while the head restraint is pressed

down.

03 Your driving environment

Seats

Manual lowering of the outer head

restraints, rear seat

Pull the locking handle closest to the head

restraint to fold the head restraint forward.

The head restraint is moved back manually

until a "click" can be heard.

Lowering the rear seat backrest

IMPORTANT

There must be no objects on the rear seat

when the backrest is to be folded down. The

seat belts must not be connected either.

Otherwise there is a risk of damaging the

rear seat upholstery.

The triple-section backrest can be folded in

different ways.

NOTE

The front seats may need to be pushed for-

wards, and/or the backrests adjusted

upwards, in order that the rear backrests

can be folded forward fully.

•

The left-hand section can be folded sepa-

rately.

•

The centre section can be folded sepa-

rately.

•

The right-hand section can only be folded

together with the centre section.

•

If the entire backrest is to be folded then

the different sections should be folded

separately.

If the centre backrest is being lowered -

fold and adjust the centre backrest's head

restraint downwards, see page 82.

The outer head restraints are lowered auto-

matically when the outer backrests are

lowered. Pull up the backrest's locking

handle

while folding the backrest for-

ward at the same time. A red indicator on

the lock catch

shows that the backrest

is no longer locked in place.

Raising takes place in reverse order.

NOTE

When the backrest has been raised, the red

indicator should no longer be showing. If it

is still showing then the backrest is not

locked in place.

03 Your driving environment

Seats

* Option/accessory, for more information, see Introduction.

WARNING

Check that the backrests and head

restraints in the rear seats are firmly locked

after raising.

Electrical lowering of the rear seat's

outer head restraints*

1. The remote control key must be in position

I or II.

2. Press the button to lower the rear outer

head restraints to improve rearward visi-

bility.

WARNING

Do not lower the outer head restraints if

there are any passengers using of the outer

seats.

Move the head restraint back manually until a

click is heard.

WARNING

The head restraints must be in locked posi-

tion after being raised.

Your driving environment -> Seats for Your Volvo Xc70 SUV Third Generation (2025-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals