Exterior lighting -> Information on bulb replacement for Your Volkswagen Atlas SUV First Generation (2018-2023)

WARNING  
Worn or dirty wiper blades reduce visibility and increase the risk of accidents and serious injuries.  
Always replace wiper blades if they are damaged or worn and are no longer cleaning the windshield sufficiently.  
NOTICE  
Damaged or dirty wiper blades can scratch the window glass.  
Do not use any cleaning materials containing solvents, hard sponges, and other sharp-edged objects because they can damage the graphite coating on  
the wiper blades.  
Do not clean the windshield and windows with fuel, nail polish remover, paint thinner, or other similar fluids.  
If there is wax residue on the windshield and rear window from car wash systems and other products, this can cause the windshield wipers to rub. Remove any  
wax residue with a special cleaner or cleaning towels.  
Exterior lighting  
Introduction  
Before performing bulb replacement, check if it is an incandescent bulb or an LEDs light. Generally, light bulbs can be replaced by yourself. If the exterior lighting on  
your vehicle is equipped with LED technology, it is not possible to change LED lights or individual LEDs by yourself. The malfunction of individual LEDs may be an  
indication that more LEDs will malfunction. If this is the case, have the LEDs checked and/or replaced if necessary by suitably qualified professionals. Volkswagen  
recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
Driving with exterior lighting that is inoperative may be against the law.  
Additional bulb specifications  
Some bulbs may have certain manufacturer specifications that differ from conventional light bulbs. The respective name will be on the bulb socket or glass bulb.  
WARNING  
Accidents can occur if the road is not well lit and the vehicle cannot be seen by others on the road, or is very difficult to see by others.  
WARNING  
Changing the bulbs incorrectly can cause accidents and serious injuries.  
Always read and observe the warnings before performing any work in the engine compartment Safety precautions for working in the engine  
compartment. The engine compartment in any motor vehicle is a potentially dangerous area that can cause serious personal injury.  
Be aware that halogen bulbs are under pressure and can break during bulb replacement.  
Only change affected bulbs when they have cooled down completely.  
Never perform a bulb replacement if you are not familiar with the required activities. If you are not sure what to do, have the work performed by an  
authorized Volkswagen dealer or authorized Volkswagen Service Facility qualified in this respect. Volkswagen recommends contacting an authorized  
Volkswagen dealer or authorized Volkswagen Service Facility.  
Components with sharp edges are located on the headlight housing and on the taillight housing. Protect your hands during bulb replacement.  
NOTICE  
Water entering the headlight housing can damage the electrical system.  
After a bulb replacement, always fit the covers on the headlight housing.  
Always check that the covers have been fitted correctly.  
Information on bulb replacement  
Please read the introductory information and heed the Warnings and Notice   
and Introduction.  
Always perform the following activities for bulb replacement in the specified sequence ⇒  
:
1. Park the vehicle a safe distance away from moving traffic on level and solid ground as soon as possible.  
2. Set the electronic parking brake.  
3. Switch the lights off.  
287  
4. Turn off the turn signal if it is activated.  
5. Vehicles with an automatic transmission: Engage the parking lock  
6. Switch the ignition off.  
.
7. Allow the orientation lighting to turn off.  
8. Allow the affected light bulbs to cool down.  
9. Check if you can see that a fuse is burnt out ⇒  
Introduction.  
10. Change the affected light bulb according to the instructions ⇒  
.
A light bulb may only be replaced with the same type of light bulb. The respective name will be on the bulb socket or glass bulb.  
Never touch a glass light bulb with bare hands. The fingerprints left behind would vaporize from the heat when the bulb is switched on and condense on the  
reflector, which would then reduce the headlight brightness.  
11. Check the bulb function after a bulb is changed.  
If the bulb does not function, the bulb may not have been inserted correctly, may have fallen out, or the connector may not have been plugged in correctly.  
12. After every bulb replacement in the front of the vehicle, have the headlight adjustment checked by an authorized Volkswagen dealer or authorized Volkswagen  
Service Facility. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
WARNING  
Failing to heed these instructions that are provided for your own safety can cause accidents and serious injuries.  
Always follow the activities in the instructions and follow the general safety precautions.  
NOTICE  
Removing and inserting trim panels and headlights incorrectly can damage the vehicle paint and body.  
When removing and inserting the headlight, be careful not to damage the vehicle paint and body.  
Replacing bulbs in LED headlights  
Please read the introductory information and heed the Warnings and Notice ⇒  
and Introduction.  
Preparations  
Only perform these activities in the specified order:  
1. Observe the information on bulb replacement and perform the activities.  
2. Open the hood.  
The headlight does not need to be removed for bulb replacement.  
Replacing a bulb in a turn signal  
Fig. 174 In the right-side of the engine compartment: Rear side of the headlights.  
Turn signal bulb holder cover.  
288