Get Jump-starting Guide for Volkswagen Atlas SUV First Generation (2018-2023)

25 A

White or clear

Green

30 A

Light green 40 A

Fuses (JCASE®)

Blue

Pink

Green

Red

20 A

30 A

40 A

50 A

Yellow 60 A

Replacing fuses

Fig. 181 Remove or install a fuse with the plastic pliers (general example).

Plastic pliers.

1. Remove plastic tongs from either the fuse box or the cover of the fuse box ﬁg. 181

2. Depending on the design of the fuse, slide the appropriately sized clamp on the plastic pliers onto the fuse from above or from the side ﬁg. 181.

3. Remove the fuse.

4. If a fuse is blown, replace with a fuse with the same rating (same color and same label) and the same size

5. After inserting the new fuse, place the plastic pliers back in the cover, if necessary.

6. Reinstall the cover or close the fuse box cover.

⇒

NOTICE

If a fuse is replaced by a fuse with a higher current rating, this could damage the electrical system in another location.

Jump-starting

Introduction

For technical reasons the vehicle must not be tow-started ⇒

. If the engine cannot start because the 12 V vehicle battery is dead, the 12 V vehicle battery on

another vehicle can be used to start your vehicle.

For vehicles with a 12 V vehicle battery in the vehicle interior or luggage compartment, the jumper cables may only be connected to the jump-start points in the

engine compartment.

WARNING

Using jumper cables and performing a jump-start incorrectly can cause the 12 V vehicle battery to explode, which can cause serious injuries.

Always read and heed the warnings and safety precautions before working on the 12 V vehicle battery

Never confuse the positive battery terminal with the negative battery terminal.

⇒

Introduction.

296

Never jump-start a vehicle with a frozen or thawed 12 V vehicle battery.

WARNING

When jump-starting the 12 V vehicle battery, a highly explosive mixture of gas builds up, which is ﬂammable and can cause serious injuries. Sparks could form

and ignite the ﬂammable gas that is released by the 12 V vehicle battery.

Always keep ﬁres, sparks, open ﬂames, and lit cigarettes far away from the 12 V vehicle battery.

Avoid discharging static electricity near the 12 V vehicle battery.

NOTICE

Tow-starting can cause damage to the vehicle.

Jump-start the vehicle to start the engine.

NOTICE

A drained 12 V vehicle battery can freeze at temperatures around +32°F (0 °C).

Always replace a frozen or thawed 12 V vehicle battery.

Ground jump-start point

Please read the introductory information and heed the Warnings and Notice ⇒

and Introduction.

Fig. 182 In the engine compartment: Negative terminal jump-start point.

The jump-start point (negative terminal) is for connecting the black jumper cable fig. 182.

The vehicle can give and receive a jump-start using this negative terminal jump-start point.

Preparing and Performing a Jump-start

Please read the introductory information and heed the Warnings and Notice ⇒

and Introduction.

Preparations

Observe the following for jump-starting:

Wear suitable eye protection and safety gloves ⇒

Pay attention to the operating instructions provided by the manufacturer of the jump-start cables.

Open the hood.

Always use a jumper cable with fully insulated terminal clamps and without any insulation defects for jump-starting

⇒

Ensure that there is sufﬁcient distance between the vehicle providing the jump-start and the vehicle receiving the jump-start, otherwise current could already

ﬂow when connecting the positive battery terminals.

297

Make sure the terminal clamps have sufﬁcient contact with metal.

Jumper cable

So that vehicles can be jump-started and can jump-start others, an appropriate jumper cable is required.

The following jumper cable wire diameters must not be fallen short of by the vehicle providing the jump-start.

Vehicles with electric drivetrain: To jump-start the vehicle with a drained 12 V vehicle battery, the wire diameter of the jumper cable must be at least 25 mm²

(0.038 in²).

Vehicles with hybrid drive: To jump-start the vehicle with a drained 12 V vehicle battery, the wire diameter of the jumper cable must be at least 25 mm²

(0.038 in²).

Vehicles with a gasoline engine: To jump-start the vehicle with a drained 12 V vehicle battery, the wire diameter of the jumper cable must be at least 25 mm²

(0.038 in²).

Vehicles with a diesel engine: To jump-start the vehicle with a drained 12 V vehicle battery, the wire diameter of the jumper cable must be at least 35 mm²

(0.054 in²).

Vehicle Receiving the Jump-start

1. Check whether the discharged 12 V vehicle battery is properly connected to the 12 V vehicle electrical system.

2. If a 12 V vehicle battery with a viewing window has been installed, check the color of the viewing window. If the viewing window is light yellow or has no color,

do not perform a jump-start and contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility.

Vehicle Providing the Jump-start

1. Pay attention to the operating instructions provided by the vehicle manufacturer.

2. Check whether the battery providing the jump-start has the same voltage (12 V) and approximately the same battery capacity as the dead 12 V vehicle battery.

Pay attention to the information printed on the battery of the vehicle providing the jump-start.

Jump-starting

Fig. 183 Diagram for connecting the jumper cables.

Positive battery terminal of the vehicle receiving the jump-start.

Positive battery terminal of the vehicle providing the jump-start.

Suitable negative terminal of the vehicle providing the jump-start: Preferably a jump-start point (negative connection), a large metal part that is bolted securely

to the engine block, or the engine block itself.

Jump-start point (negative terminal) of the vehicle receiving the jump-start.

Only connect the jumper cables in the sequence A – B – C – D ﬁg. 183.

1. Switch the ignition off on both vehicles.

2. In the engine compartment, open the cover on the positive battery terminal (+) of the 12 V vehicle battery, if ﬁtted.

3. Connect one end of the red jumper cable to the positive battery terminal (+) of the 12 V vehicle battery with the discharged 12 V vehicle battery ﬁg. 183

⇒

4. Connect the other end of the red jumper cable to the positive battery terminal (+) on the vehicle providing current ﬁg. 183

5. Connect one end of the black jumper cable preferably to the negative terminal (–) jump-start point on the vehicle with the 12 V vehicle battery providing current

ﬁg. 183

298

Or: If there is no negative terminal (–) jump-start point, connect the end of the black jumper cable to a large metal part that is bolted securely to the engine

block, or the engine block itself, on the vehicle with the 12 V vehicle battery providing current ﬁg. 183

6. Connect the other end of the black jumper cable to the negative terminal (–) jump-start point on the vehicle with the discharged 12 V vehicle battery ﬁg. 183

⇒

7. Route the jumper cables so that they cannot become caught in moving parts in the engine compartment.

Start the engine

1. Start the engine in the vehicle that is providing current and allow it to idle.

2. Wait a few minutes and then start the vehicle's engine with the discharged 12 V vehicle battery. If the engine does not start, stop the starting process after ten

seconds, and try again after approximately one minute.

If the engine still will not start, contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility.

Removing the jumper cables

1. Before disconnecting the jumper cables, switch off the low beam headlight if necessary.

2. In the vehicle with the drained 12 V vehicle battery, switch on the blower for the air conditioner and the rear window defroster. This will reduce any voltage

surges that may occur when disconnected.

3. Once the vehicle has been jump-started, always disconnect the jumper cables in the order D – C – B – A ﬁg. 183.

4. Close the cover of the positive terminal (+), if ﬁtted.

After successful jump-starting, have the 12 V vehicle battery checked by an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen

recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.

WARNING

Performing a jump-start incorrectly can cause the 12 V vehicle battery to explode, which can cause serious injuries.

Always wear suitable protective eyewear and protective gloves, and never bend over the 12 V vehicle battery.

Always connect the positive cable ﬁrst and then the negative cable.

Never connect the negative terminal to parts of the fuel system or to the brake lines.

Ensure that there is no contact between the non-insulated parts of the terminal clamps.

Make sure the cable insulation is free from any defects.

Make sure that the cable that is connected to the positive battery terminal on the 12 V vehicle battery does not come into contact with any vehicle

components that conduct electricity.

NOTICE

A drained 12 V vehicle battery can freeze at temperatures around +32°F (0 °C).

Do not jump-start a frozen or thawed 12 V vehicle battery.

Towing

Introduction

Towing requires practice, particularly if a towing cable is used. Both drivers should be familiar with the special considerations when towing. Inexperienced drivers

should not tow.

Follow all applicable laws when towing.

Always make sure the towing force does not exceed the permitted level and there are no shock loading conditions. There is always the risk of the coupling becomin

overloaded when driving off-road.

WARNING

The vehicle handling and braking efﬁciency will change considerably when it is towed.

WARNING

Never tow a vehicle that has no electrical power.

Never turn off the ignition with the starter button while towing. Otherwise, the electronic steering column lock could engage suddenly. The vehicle cannot

be steered if this happens. This can result in crashes, serious injuries, and a loss of control of the vehicle.

Never remove the remote control vehicle key from the ignition lock while towing. Otherwise, the mechanical steering column lock or steering lock could

299

Jump-starting for Your Volkswagen Atlas SUV First Generation (2018-2023)

Related Topics

Popular Owner Manuals

Latest Owner Manuals