Safety belts -> Using safety belts for Your Volkswagen Atlas SUV First Generation (2018-2023)

If the belt webbing or other parts of the safety belt are damaged, the safety belts could tear during a collision or sudden breaking maneuver.  
Have damaged safety belts replaced immediately with new safety belts that are approved for the vehicle by Volkswagen. Safety belts that are stretched  
during a collision must be replaced by an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen recommends contacting  
an authorized Volkswagen dealer or authorized Volkswagen Service Facility. It may be necessary to replace them even if there is no visible damage.  
Check the safety belts' anchorage points as well.  
Never try to repair, modify, or remove the safety belts yourself. Have all repairs to safety belts, safety belt retractors, and buckle components performed  
only by an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen recommends contacting an authorized Volkswagen  
dealer or authorized Volkswagen Service Facility.  
Fasten seat belts reminder and seat belt safety indicator  
Please read the introductory information and heed the Warnings and Notice   
Introduction.  
Fig. 26 In the instrument cluster display: warning light.  
The driver or front passenger has not fastened their safety belt. Fasten all safety belts.  
When the ignition is switched on, several warning and indicator lamps light up temporarily as a function check. They then turn off after a few seconds.  
A chime also sounds.  
When the ignition is switched on, the red  
warning light comes on for six seconds. A chime also sounds for up to six seconds if the driver safety belt is not  
fastened. The chime ends when the driver fastens their safety belt. The warning lamps and chime go off when the driver and front passenger have fastened their  
safety belts.  
If the driver and front passenger do not both fasten their safety belts within 10 seconds after the warning chime has ended and the vehicle is driving at a speed  
above approx. 15 mph (approx. 25 km/h), the chime sounds again for approx. 6 seconds, then stops for approx. 24 seconds, and then sounds again for approx. 6  
seconds. The same happens if one of the safety belts is released while driving. The red  
warning light comes on. A warning chime also sounds for up to two  
minutes at 24-second intervals. The chime does not sound at speeds below approx. 5 mph (approx. 8 km/h).  
When the ignition is switched on, the red  
warning light comes on until the driver and front passenger have both fastened their safety belts.  
WARNING  
The risk of serious and fatal injuries increases if the safety belts are not worn or are worn incorrectly. The optimum protection is only achieved if the safety belts  
are worn and used correctly.  
Using safety belts  
Please read the introductory information and heed the Warnings and Notice ⇒  
Introduction.  
Checklist  
Using safety belts  
:
Check the condition of all of the safety belts regularly.  
Keep safety belts clean.  
Always keep foreign objects and fluids far away from the safety belt, the safety belt buckle, and the slot in the safety belt buckle.  
Do not pinch or damage the safety belt and/or belt buckle, for example closing it in a door.  
Never remove, modify, or repair the safety belt and belt fastening elements.  
Always fasten the safety belt correctly before you begin driving and keep it fastened while driving.  
Twisted safety belt  
47  
If the safety belt is difficult to pull out of the belt guide, the safety belt may have been pulled out too quickly when positioning the belt and may have become twisted  
within the side trim panel:  
1. Slowly and carefully pull the safety belt out completely by the belt buckle.  
2. Untwist any twisted sections of the safety belt and guide the belt back slowly by hand.  
If you cannot untwist the safety belt, fasten the safety belt anyway. The twist must not be in a section of the belt that rests directly on the body. Go to an authorized  
Volkswagen dealer or authorized Volkswagen Service Facility immediately to have the belt untwisted. Volkswagen recommends contacting an authorized  
Volkswagen dealer or authorized Volkswagen Service Facility.  
Lockable safety belt  
The safety belts on the rear seats and the safety belt on the front passenger seat are lockable and have an emergency locking function. With the locking function,  
you can adjust the safety belt so that a child restraint is properly installed Securing a child restraint with a safety belt .  
Safety belts may only be locked for certain child restraint systems Child restraints – overview.  
An activated locking mechanism must be released when a vehicle occupant fastens their safety belt. To release the locking mechanism, push the red button in the  
belt buckle and guide the belt back fully by hand.  
WARNING  
Incorrect handling of the safety belts increases the risk of severe or fatal injuries.  
Check the safety belts and associated components regularly to ensure they function correctly.  
Safety belts cannot be repaired; they must be replaced.  
Always keep the safety belts clean.  
Do not pinch or damage the safety belt or allow it to rub against any objects with sharp edges.  
Always keep the belt buckle and insertion guide for the belt buckle free of foreign objects and fluids.  
Fastening and unfastening the safety belts  
Please read the introductory information and heed the Warnings and Notice ⇒  
Safety belts that are fastened correctly hold vehicle occupants in the correct position during braking maneuvers or in a collision, in order to provide the maximum  
protection ⇒  
Introduction.  
.
Fastening the safety belt  
Fig. 27 Inserting the buckle tongue into the safety belt buckle.  
Always fasten the safety belts before driving.  
1. Adjust the front seat and head restraint correctly Seating position.  
48