Driver assistance systems -> Lane Change System (Side Assist) for Your Volkswagen Atlas SUV Second Generation (2024-2025)

If you do not respond, the system can brake the vehicle and keep it in its lane. The following indicator light will come on in the  
instrument cluster display:  
System is regulating.  
You can cancel the regulation at any time by accelerating rapidly, braking or steering as the traffic situation allows.  
If Emergency Assist is active, other road users will be warned as follows:  
The emergency flashers are switched on after a short delay.  
The vehicle's horn sounds, depending on the speed.  
If the remaining stopping distance is sufficient, the vehicle slows down, if necessary, to a stop.  
As soon as the vehicle comes to a standstill, the following happens:  
The electronic parking brake is switched on.  
Gear P is engaged.  
The doors are unlocked.  
The interior lighting is switched on.  
Depending on the vehicle equipment, an emergency call is made.  
Troubleshooting  
Please read the introductory information and heed the Warnings and Notice   
Introduction.  
Semi-automated vehicle assistance in a medical emergency (Emergency Assist) not available  
Malfunction or fault. The yellow indicator light turns on. In addition, a message is shown in the instrument cluster display.  
1. Stop the engine and restart.  
2. If the problem persists, turn off Emergency Assist and contact suitably qualified professionals. Volkswagen recommends  
contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
The system is triggered unwantedly or is functioning differently than expected  
Malfunction or fault.  
Switch off the Lane Keeping System (Lane Assist).  
Do not use semi-automated driving assistance (Travel Assist).  
Contact suitably qualified professionals to have the system checked. Volkswagen recommends contacting an authorized  
Volkswagen dealer or authorized Volkswagen Service Facility.  
Controls are responding differently than expected  
Moisture, dirt and grease may limit the functioning of the controls.  
1. Always keep the control panels clean and dry.  
Lane Change System (Side Assist)  
Introduction  
The Lane Change System (Side  
Assist) helps the driver to discern the  
traffic situation behind the vehicle.  
Radar sensors behind the rear bumper cover monitor the area behind the vehicle. The system measures the distance and  
difference in speed to other vehicles and informs the driver through visual signals in the outside mirrors.  
Only use Side Assist on secure roads.  
248  
Speed range  
If Side Assist is switched on, this function is available from approx. 15 km/h (approx. 9 mph). Side Assist is deactivated at  
speeds below approx. 10 km/h (approx. 6 mph).  
WARNING  
Side Assist is not a replacement for the driver's attention and works only within the system limitations. Side Assist cannot  
detect all driving situations and all objects in the surrounding environment, and may not provide warnings, may provide  
warnings with a delay, or may provide warnings in a way that is not desired. If you are careless, there is a risk of accidents,  
serious injuries and death.  
Always stay attentive and do not rely solely on the system. The driver is always responsible for control of the  
vehicle and changing lanes.  
Observe the system limitations Side Assist system limitations .  
Always adapt your speed and distance to vehicles driving ahead based on the visual, weather, road, and traffic  
conditions.  
Always keep your hands on the steering wheel so that you are prepared to steer at any time.  
Pay attention to the displays in the outside mirror housings and in the instrument cluster display, and act  
accordingly.  
Side Assist system limitations  
Please read the introductory information and heed the Warnings and Notice ⇒  
Introduction.  
Limits of the sensor system  
Side Assist detects driving situations via the radar sensors in the rear area.  
Note the limits of the radar sensors Limits of the sensor system and always pay attention!  
Functional limitations  
In addition to the situations specified in the sensor system limitations, Side Assist may not correctly interpret the traffic situatio  
in the following situations, among others:  
When driving in the center of two lanes.  
When lanes have different widths.  
When certain types of equipment are on the side of the road, such as high or offset guard rails.  
The Lane Change System (Side Assist) does not detect any stationary vehicles either.  
Restricted visibility  
Sunlight may reduce the visibility of the visual display in the outside mirror.  
Calibration  
After the delivery of the vehicle, the radar sensors are calibrated within the first kilometers driven. This happens only once, an  
then again if the sensor technology has been repaired. The range of the sensors may be limited during the calibration phase.  
Driving with Side Assist  
Please read the introductory information and heed the Warnings and Notice ⇒  
Introduction.  
249  
Switching on and off  
You can view the current condition of Side Assist on the instrument cluster display and in the Infotainment system. You can  
also switch Side Assist on and off there.  
In the instrument cluster display:  
1. Press the  
button.  
2. Switch Side Assist on or off.  
Depending on the vehicle equipment, the  
and high beam lever.  
button is located either on the multi-function steering wheel or the turn signal  
In the Infotainment system:  
1. Open the Assistance systems menu.  
2. Switch Side Assist on or off in the corresponding submenu.  
When it is switched on, the yellow indicator light  
Deactivation due to trailer mode  
in the outside mirrors comes on once briefly.  
If you use the trailer hitch installed at the factory and have made the required electrical connection, Side Assist will switch off  
automatically. Once a trailer is connected to the vehicle electrical system and the driver starts to drive, a message will appear  
in the instrument cluster display stating that Side Assist is deactivated. Once you have disconnected the electrical connection,  
Side Assist will be automatically switched on again.  
For trailer hitches that were not installed at the factory, you must switch Side Assist off and on again manually.  
Displays in the outside mirror  
Fig. 110 In the mirror glass of the outside mirrors: indicator of Side Assist.  
Blinking: a vehicle in the blind spot has been detected and the turn signal is also activated towards the detected vehicle.  
Lights up: the vehicle you are driving is being overtaken or you are overtaking another vehicle with a difference in speed  
of up to approx. 15 km/h (approx. 9 mph).  
There is no indicator if the passing speed is clearly faster.  
The faster another vehicle approaches, the sooner the display in the outside mirror will turn on.  
250  
Lane change system “Side Assist Plus”  
In vehicle with a Lane Keeping System (Lane Assist), a corrective steering intervention warns you when a possible critical  
situation is detected when changing lanes (information level, warning level), if Lane Assist is switched on. The steering  
intervention also occurs if you activate the turn signal for the respective side. If you oversteer the steering intervention, an  
additional warning is provided by a steering wheel vibration. Steering wheel vibration must also be activated in the Assistance  
systems menu in the Infotainment system.  
Brightness  
The brightness of the visual display adapts it self automatically to the ambient brightness.  
You can set the default brightness of the display in the Assistance systems menu of the Infotainment system. Side Assist is no  
active while adjusting the settings.  
Troubleshooting  
Please read the introductory information and heed the Warnings and Notice ⇒  
Introduction.  
Side Assist malfunction  
Malfunction or fault. The yellow indicator light in the instrument cluster display lights up. In addition, the yellow central warning  
light comes on.  
1. Stop the engine and restart.  
2. If the problem persists, contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen  
recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
Malfunctioning sensor view, malfunction message, system switches off automatically  
Clean the radar sensors and remove stickers or attachments from the radar sensors or the bumper Exterior care and  
cleaning, Sensors and Cameras.  
Check if there is any noticeable damage Sensors and Cameras.  
If the problem persists, contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen  
recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
The system is functioning differently than expected  
The radar sensors could be dirty. Clean the radar sensors Exterior care and cleaning.  
The radar sensors could be covered by water.  
The view of the radar sensors is limited due to weather conditions, such as snow, or due to dirt, soap residue or coatings  
Clean the radar sensors Exterior care and cleaning.  
The system limitations are not adhered to Side Assist system limitations .  
The vehicle could be damaged in the radar sensor area, for example from parking barriers. Check if there is any  
noticeable damage Sensors and Cameras.  
The view of the radar sensors is limited by attachments, bicycle rack systems or stickers. Clear the area around the field  
of view of the radar sensor Sensors and Cameras.  
Painting work was carried out on or structural modifications were made to the area around the radar sensors, to the rear  
of the vehicle or to the suspension Repairs and technical modifications.  
The side mirrors have been covered with after-market tinting films Repairs and technical modifications.  
If the problem persists, contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility. Volkswagen  
recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
Controls are responding differently than expected  
251  
Moisture, dirt and grease may limit the functioning of the controls.  
1. Always keep the control panels clean and dry.  
252