2003-2015 Volkswagen Caddy SUV Legislative and technical conditions for converting wheel and tyre combinations User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Legislative and technical conditions for converting wheel and tyre combinations for Your Volkswagen Caddy SUV Third Generation (2003-2015)

Amarok 2011 ➤ , Caddy 2004 ➤ , Caddy 2011 ➤ , Caddy Kasten/Kombi 1996 ➤ ...  
Wheels and Tyres Guide - Edition 01.2011  
2
Legislative and technical conditions  
for converting wheel and tyre combi‐  
nations  
2.1  
Legislative conditions for converting  
wheel and tyre combinations  
The manufacturer is issued with a general operating permit (GTA  
in accordance with § 20 StVZO (German road traffic and licensing  
regulations) and EU operating permit) for the overall vehicle with  
all parts for specific conversions.  
Conversions of wheels and tyres can only be carried out under  
certain conditions. When doing this, the following points must be  
observed:  
♦ If the size of wheel and tyre, with an indication of the load index  
and the speed symbol, is included in the vehicle GTA and EU  
operating permit/type approval ⇒ page 6 , this wheel and  
tyre combination can be fitted on the vehicle without any prob‐  
lem.  
It is not necessary for the wheel and tyre combination specified  
in the registration certificate part I (certificate of registration) to be  
fitted. All combinations approved in the vehicle GTA or EU oper‐  
ating permit/type approval ⇒ page 6 may be fitted to the  
vehicle.  
♦ There is no general type approval according to § 22 StVZO for  
the modifications recommended by Volkswagen AG (see at‐  
tachment or Appendix 2 to Parts Certificate).  
♦ Unless the wheels and/or tyres are included in the relevant  
vehicle GTA or EU operating permit/type approval, the vehicle  
will no longer meet the requirements of the road traffic regu‐  
lations if converted.  
lk  
These versions are based on the conditions valid in the European  
Union and no guarantee can be provided for their completeness.  
In some cases there are different legislative requirements outside  
the European Union.  
The table included in the attachment or Appendix 2 to Parts Cer‐  
tificate shows the Volkswagen AG recommended and TÜV  
NORD Mobilität GmbH Co. KG tested wheel and tyre combina‐  
tions on VW vehicles and also the conditions to be observed for  
fitting. The use of genuine disc-type wheels on a vehicle to which  
they have not been allocated is not permissible.  
The list of possible conversions deals with combinations that meet  
the requirements of Volkswagen AG with regards to road handling  
and road safety. They are the result of practical trials and are  
therefore recommended by Volkswagen AG.  
Refer also to the new vehicle registration documents that were  
issued from 01.10.2005 ⇒ page 5 .  
2.2  
Technical conditions for converting  
wheel and tyre combinations  
The wheel and tyre combinations and conversions listed in the  
tables of the individual vehicles refer exclusively to Volkswa‐  
gen genuine wheels.  
Approval of wheel and tyre combinations or a change to  
wheels from the accessories trade is not possible with the  
parts certificate attached here.  
2. Legislative and technical conditions for converting wheel and tyre combinations  
3
Amarok 2011 ➤ , Caddy 2004 ➤ , Caddy 2011 ➤ , Caddy Kasten/Kombi 1996 ➤ ...  
Wheels and Tyres Guide - Edition 01.2011  
Tubeless radial tyres may only be fitted to rims with a safety  
hump feature on the shoulder.  
If the wheel and tyre combinations listed are used, the asso‐  
ciated tyre inflation pressures must be adhered to. The tyre  
inflation pressure for summer tyres can be found on the sticker  
on the inside of the tank flap or in the tables of the individual  
vehicles.  
Sufficient clearance to the wheels and tyres at parts of the  
wheel housing, suspension and braking system is assured if  
the notes and specifications established in the parts certificate  
are observed in all operating conditions.  
Unless otherwise stated, snow chains may only be fitted to the  
drive wheels.  
The same sized wheels and tyres must be used at the front  
and rear of the vehicle. On vehicles with all-wheel drive, tyres  
must be of the same manufacturer and have the same tread  
profile.  
2.3  
Additional wheel housing extensions  
lk  
(flaps)  
For technical reasons some vehicles require wheel housing ex‐  
tensions (flaps) on the wing or bumper -arrows- when using  
certain wheel and tyre combinations.  
Please check if there is a requirement to remove the flaps.  
The information is located in the overview table for the respective  
vehicle.  
2.4  
„Series 80“ tyres  
Tyres of the „80“ series (e.g. 145/80 R 13 74 S) will replace the  
„82“ series (e.g. 145/82 R 13 74 S). Legislation stipulates that „82“  
series tyres may be replaced by „80“ series tyres without having  
been entered in the vehicle documents.  
The condition for this is that the „80“ series tyres have the same  
width are of the same type – cross-ply or radial belted – and have  
the same or higher load index.  
If only „80“ series tyres are entered in the vehicle documents, „82“  
series tyres may only be used if an entry has been made in the  
vehicle documents.  
4
Rep. gr.44 - Wheels, tyres, vehicle geometry  

Related Topics

Popular Owner Manuals