Seat belts -> Warning lamp for Your Volkswagen Caddy SUV Fifth Generation (2020-2025)

Warning lamp  
Fig. 1 On the display of the instrument cluster: Warning  
lamp.  
Fig. 2 On the display of the instrument cluster: Belt status  
display for the rear seats.  
The red warning lamp lights up when the ignition is switched on and the vehicle occupants have not fastened their  
seat belts.  
An acoustic signal sounds at the start of a journey or if the seat belts are unfastened while the vehicle is travelling at  
speeds of more than around 25 km/h (15 mph). The red warning lamp will also flash→ Fig. 1.  
The red warning lamp will not go out until all vehicle occupants have fastened their seat belts when the ignition is  
switched on.  
Belt status display for the rear seats  
The belt status indicator in the instrument cluster display shows the driver the number of seats detected when the  
ignition is switched on. Additionally, a black or white symbol indicates whether there are adult passengers in the rear  
seats → Fig. 2. The black symbol shows the number of seats that are not occupied. The filled-in white symbol shows  
the number of seats that are occupied. The display goes out after around 60 seconds.  
The belt status display for the rear seats is battery operated using a radio standard . Other radio-based systems,  
such as two-way radios, may interfere with the system →  
.
Before setting off, the driver must check whether the number of seats shown in the instrument cluster corresponds  
to the number of seats in the passenger compartment . If the number does not match, have the system checked  
by a qualified workshop (→ Belt status indicator).  
WARNING  
Ignoring the belt status indicator can cause serious injury. The system is not a substitute for the full concentration  
of the driver.  
Before setting off, always check whether the number of seats shown in the instrument cluster corresponds to the  
54  
number of seats in the passenger compartment.  
Before setting off, always check that all vehicle occupants have fastened their seat belts correctly.  
WARNING  
Incorrectly fastened or unfastened seat belts increase the risk of severe or fatal injuries. Seat belts will only offer the  
optimum level of protection when they are fastened and used properly.  
WARNING  
The buckle-up request is designed to detect adult persons. If a seat is occupied by lighter persons, in particular  
children, the detection will not be reliable. The buckle-up request also does not respond or only in a limited way if  
child seats and seat supports are used.  
Always ensure that all vehicle occupants, especially children, have fastened their seat belts properly.  
The vehicle may still detect seats which have been removed but left near the  
vehicle.  
The belt status indicator must be approved by a qualified workshop if seats are replaced or retrofitted at a  
later date, for example a third row of seats is added (→ Third seat row)→ Warning lamp. Volkswagen  
Commercial Vehicles recommends using a Volkswagen Commercial Vehicles dealership for this purpose.  
Troubleshooting  
Belt status indicator faulty  
The yellow indicator lamp lights up continuously. In addition, a message may be displayed in the instrument cluster.  
The battery in the radio system is too weak on at least one seat.  
Go to a qualified workshop.  
Check the rear seat and replace the battery if necessary.  
Belt status indicator defective  
The yellow indicator lamp lights up continuously. In addition, a message may be displayed in the instrument cluster.  
Go to a qualified workshop.  
Belt status indicator faulty  
The indicator lamp lights up continuously. In addition, a message may be displayed in the instrument cluster.  
The battery in the radio system is too weak on at least one seat.  
Go to a qualified workshop.  
Check the rear seat and replace the battery if necessary.  
55