Get Driver assist systems -> Cruise Control System (CCS) Guide for Volkswagen California Van Third Generation (2015-2024)

—If there is a large difference in the speed of rotation of the rear wheels

—If the drive train is heavily loaded

—If the mechanical teeth of the differential lock are “tooth to tooth”: The symbol in the button and the yellow

indicator lamp in the instrument cluster flash.

WARNING

The steering ability of the vehicle is very restricted when the differential lock is engaged. This could mean that you

lose control over the vehicle and cause serious injuries.

● Never engage the differential lock if you are driving on a paved road surface, the vehicle is being towed or if the

tyres have no traction.

NOTICE

Never engage the differential lock if you are driving on a paved road surface. If the differential lock is engaged, the

axles, gearbox and drive shaft will be subjected to stresses, loading and damage during cornering.

If the differential lock is switched off when driving through a bend, this may cause a small shudder to pass

through the vehicle. This is caused by the release of tension forces in the drive train. This is normal and is not

a indication of damage to the vehicle.

If you drive through bends with the differential lock engaged, the wheels “rub” on the road surface. You

might be able to hear this. The “rubbing” of the tyres - especially on solid ground - will lead to increased wear

on the tyres.

Introduction

The cruise control system(CCS) helps to maintain a speed set by the driver.

Speed range

The CCS

is available when driving forwards at speeds from around 30 km/h (around 20 mph).

Driving with the cruise control system

You can exceed the stored speed at any time, e.g. to overtake. Control is interrupted for the duration of the

acceleration manoeuvre and is then resumed with the stored speed.

Displays

When the cruise control system is switched on, the instrument cluster display shows the stored speed and the status

of the cruise control system.

Depending on the driving situation and the instrument cluster version, one of following indicator lamps lights up:

Cruise control system switched on.

Cruise control system switched on, control intervention active.

The indicator lamps are shown as small icons or are greyed out if the cruise control system is not regulating.

If no speed is stored, the instrument cluster display shows

instead of the speed.

223

Changing gear

Cruise control is interrupted as soon as you press the clutch pedal and is resumed automatically after the gear

change.

Driving downhill

The vehicle cannot maintain the stored speed in all driving situations. Always be prepared to brake the vehicle.

1. Shift down before extended downhill stretches.

In this way you will make use of the engine braking effect and relieve the load on the brakes.

WARNING

Use of the cruise control system can lead to accidents and serious injuries if traffic does not allow you to drive at a

safe distance at a constant speed.

● Never use the cruise control system in heavy traffic, if the distance to the vehicles in front is insufficient, on steep

or winding roads, on slippery road surfaces e.g. due to snow, ice, wet roads, loose chippings, or on flooded roads.

● Never use the cruise control system when driving offroad or on unpaved road surfaces.

● Adapt your speed and distance from the vehicles ahead to suit visibility, weather, road and traffic conditions.

● Always switch cruise control off after use to avoid unintentional operation.

● It is dangerous to use a set speed that is too high for the prevailing road, traffic or weather conditions.

Operating CCS via the multi-function steering wheel

Fig. 1 Left-hand side of the multifunction steering wheel.

Switching on

1. Press the

button.

No speed has been stored yet and the speed is not yet controlled.

Starting control

1. While driving, press the

The CCS

stores and regulates the current speed.

button.

224

Adjusting the speed

You can adjust the stored speed while the cruise control system is regulating the speed:

+ 1 km/h (1 mph):

Press the

button.

- 1 km/h (1 mph):

Press the

+ 10 km/h (5 mph):

Press the button. Pressing it for the first time switches to the next highest 10 km/h or 5 mph interval:

- 10 km/h (5 mph):

Press the button. Pressing it for the first time switches to the next lowest 10 km/h or 5 mph interval:

Press and hold the or button to continuously change the stored speed.

The vehicle adapts the current speed by accelerating or reducing acceleration. The vehicle is not actively braked.

Cancelling control

1. Briefly press the

button.

Or: Depress the brake pedal.

The speed is stored in the memory.

Restarting control

1. Press the

button.

The cruise control system resumes operation with the stored speed and regulates the speed again.

Switching off

1. Press the

button.

The cruise control system is switched off and the stored speed is deleted.

Changing to the speed limiter

1. Press the

button.

2. Select the speed limiter on the instrument cluster display.

The cruise control system is switched off.

Troubleshooting

Fault in the cruise control system

Malfunction. The indicator lamp lights up yellow.

1. Switch off theCCS

and go to a suitably qualified workshop.

Fault in cruise control system

225

Driver assist systems -> Cruise Control System (CCS) for Your Volkswagen California Van Third Generation (2015-2024)

Related Topics

Driver assist systems

Popular Owner Manuals

Latest Owner Manuals