FOX 2004 ➤
3 - Cyl. injection engine - Edition 12.2009
Removal
– Install the Extractor -T10094- over the ignition coil with final
power stage.-arrow-
– Install the Hook -T10118- as illustrated.
– Unlock the connector block carefully and remove the connec‐
tor.
– Remove ignition coil with final power stage.
Installation
– Install the Extractor -T10094- over the ignition coil with final
lk
power stage.
– Install the ignition coil with final power stage in the -arrow- di‐
rection on the engine cylinder head.
– Connect the connector to the ignition coil with final power
stage until fitting it audibly.
1.3
Safety measures
To prevent injuries in people and/or destruction of the injection
and ignition system, take into consideration the following:
♦ Do not touch nor disconnect ignition cables with the engine in
operation or upon start.
♦ Only connect or disconnect the injection and ignition system
cables, including measurement device cables, with the ignition
switched off.
If during a test drive, it is necessary to use test and measuring
equipment, observe the following:
♦ The measurement and test devices must be fastened to the
back seat and operated by another mechanic from then on.
If the measurement and test devices are operated from the front
passenger seat, the person seating there could be injured by the
passenger airbag being triggered, in case of an accident.
♦ To make the engine rotate with the starter, without running it:
– Disconnect all 4-pole connectors -arrows- for the ignition coils.
1. Ignition system - repair
111
English 
