Memory buttons
On the outside of the driver seat: memory buttons.
The memory buttons can be used to store and recall settings for the driver seat and the exterior mirrors.
Storing driver seat and exterior mirror settings for driving forwards
1. Switch on the electronic parking brake.
2. Put the gearbox into neutral.
3. Switch on the ignition.
4. Adjust the driver seat and exterior mirrors.
5. Press the
→ Fig. 1 button for longer than 1 second.
6. Within approximately 10 seconds, press the desired memory button → Fig. 1.
An acoustic signal confirms that the settings have been stored.
Storing the front passenger exterior mirror settings for reversing
1. Switch on the electronic parking brake.
2. Put the gearbox into neutral.
3. Switch on the ignition.
4. Press the desired memory button → Fig. 1.
5. Select reverse gear.
6. Adjust the exterior mirror on the front passenger side so that you have a good view of the kerb area, for example.
The settings for the mirror position will be saved automatically and assigned to the vehicle key that was used to unlock the
vehicle.
Opening the driver seat and exterior mirror settings
1. When the vehicle is stationary, the ignition is switched off and one vehicle door is open, briefly press the corresponding memory
button.
After around 10 minutes, the stored positions can no longer be adjusted automatically. The adjustment process is cancelled if
one of the memory buttons is pressed again.
with the ignition switched on or the vehicle door closed, press and hold the corresponding memory button until the stored
positions have been reached.
The front passenger exterior mirror will leave the position saved for reversing automatically if the vehicle drives forwards at a speed of
at least around 15 km/h (around 10 mph) or if you turn the rotary knob for the exterior mirror out of the position and into another
position.
English 
