Opening and closing -> Sliding window for Your Volkswagen Multivan SUV Sixth Generation (2015-2024)

Opening and closing the sliding window  
There are two sliding window variants:  
Press the window handle together from top to bottom(arrows on the handle).  
Pull together window handle while pulling inwards(without arrows on the handle).  
Opening the sliding window in the side panel  
1. Press together the window handle.  
Or: Press the window handle and pull it towards the inside of the vehicle.  
2. Keep the window handle in this position and open the sliding window.  
3. Make sure that the sliding window is securely engaged in one of the available positions.  
4. Release window handle.  
Closing the sliding window in the side panel  
1. Press together the window handle.  
Or: Press the window handle and pull it towards the inside of the vehicle.  
2. Keep the window handle in this position and close the sliding window.  
3. Release window handle.  
Opening and closing the sliding window in the partition  
1. Pull the window handle and open or close the sliding window.  
WARNING  
In the event of a sudden braking manoeuvre or accident, a sliding window that is not securely engaged could move  
forward and cause injuries.  
Always allow the sliding window to engage securely.  
116  
Troubleshooting  
One-touch opening and closing do not work  
If the 12-volt vehicle battery has been disconnected or discharged when the windows were not fully closed, the one-  
touch opening and closing function does not work and must be reactivated:  
1. Switch on the ignition.  
2. Close all windows and doors.  
3. Pull and hold the button for the respective window for several seconds.  
4. Release the button.  
5. Pull and hold the button again.  
The one-touch opening and closing function is now ready for operation again.  
The automatic electric window functions can be reactivated either individually or for several windows at the same  
time.  
Window cannot be closed  
1. Check whether there is an obstacle in the movement path.  
2. Try to close the window again within a few seconds by pulling and holding the button.  
The roll-back function is then deactivated for a small operating range of the closing path. The roll-back function will  
be activated again if the closing operation takes longer than a few seconds.  
The window will then stop if movement is again stiff or if there is an obstacle and opens automatically again.  
1. If the fault persists, the system should be checked by a suitably qualified workshop.  
Touch panels do not react as expected  
Moisture, dirt and grease can impede the functioning of the touch panels.  
1. Always keep touch panels clean and dry.  
117