Get Volkswagen information system -> Driving data Guide for Volkswagen Polo SUV Fourth Generation (2001-2009)

12/29/2015

Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland

⇒ BookletProvision for a

mobile telephone,

⇒ BookletNavigation

system, /

Display telephone information.

Telephone

⇒ BookletRadio/navigation

system,

Using the telephone.

→ Instrumentsꢀ ,

→ Menu and system

settings (SETUP) ꢀ

Display and storage of current warning or information texts.

Vehicle status /

Vehicle

The menu option only appears if warning and information texts are available.

Driving data

First read and observe the introductory information and safety warnings →

ꢀ

Introduction

The multifunction display (MFD) shows a variety of travel and fuel consumption data. MFA is called up from the selection menu → Using the

selection menu in the instrument cluster ꢀ .

Switching between displays

Vehicles without a multifunction steering wheel: press the rocker switch

on the windscreen wiper lever → Fig. 15ꢀ.

button → Fig. 16ꢀ.

Vehicles with a multifunction steering wheel: press the

Driving data recorder

The MFD is fitted with 3 automatic recorders:

Since start

Since refuel

Long-term

The currently selected memory is shown in the display.

Press the

button on the windscreen wiper lever or press the

button on the multifunction steering wheel to

switch between recorders when the ignition is switched on and the recorder is displayed.

Display

Function

Display and storage of gathered driving and consumption values from the time the ignition is switched on until it

is switched off.

Since start

If the journey is continued within approximately 2 hours of the ignition being switched off, the new values are

also taken into account. The memory will automatically be deleted if the journey is interrupted for more than 2

hours.

Display and storage of the collected driving and consumption values. The memory is deleted automatically

when the vehicle is refuelled.

Since refuel

Long-term

The memory collects journey data for any number of individual journeys up to a total of 19 hours and

59 minutes or 99 hours and 59 minutes journey time or 1,999.9 km or 9,999.9 km distance travelled. If one of

these maximum limits^a)is exceeded, the memory is automatically deleted and reset to 0.

Deleting the driving data recorder manually

25/32

12/29/2015

Select the memory that you wish to delete.

Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland

Press and hold the

button on the windscreen wiper lever, or the

button on the multifunction steering

wheel, for approximately 2 seconds.

Personal selection of displays

You can set which MFD display should appear in the instrument cluster using the

button and the

and

Multifunction display function buttons in the infotainment system → Menu and system settings (SETUP) ꢀ .

Examples of display

Display

Function

The current fuel consumption is displayed in litres/100 km while the vehicle is in motion, and in litres/hour while

the vehicle is stationary.

Consumption

The average fuel consumption will be shown after a distance of approximately 300 metres has been travelled.

The display will show dashes until this point. The displayed value is updated approximately every second.

Av. consumption

Range

Approximate calculation of the distance in km that can still be travelled with the current fuel level under the

current driving conditions. One factor used for calculating this figure is the current level of fuel consumption.

Travel time

Distance

Driving time in hours (h) and minutes (min) that has elapsed since the ignition was switched on.

The distance travelled in km since the ignition was switched on.

The average speed will be shown after a distance of approximately 100 metres has been travelled. The display

will show dashes until this point. The displayed values will be updated approximately every 5 seconds.

Av. speed

Digital speed display

Current vehicle speed displayed digitally.

Speed warning --- km/h

or Warning at --- mph

If the saved speed (within the range of 30 km/h (18 mph) and 250 km/h (155 mph)) is exceeded, a signal tone

will be given, along with a visible warning if required.

Oil temp.

Coolant

Current temperature of the engine oil displayed digitally.

Current coolant temperature displayed digitally.

Saving a speed for the speed warning

Select display warning at --- km/h or Warning at --- mph.

Press the

button on the windscreen wiper lever, or the

button on the multifunction steering wheel to

save the current speed and activate the warning system.

If necessary, use the

rocker switch on the windscreen wiper lever, or the

buttons on the multifunction

or button again,

steering wheel, within approximately 5 seconds to set the desired speed. Then press the

or wait a few seconds. The speed is now saved and the warning is activated.

To deactivate, press the

button. The stored speed will be deleted.

^a)Changes depending on the instrument cluster version.

Assist systems menu

First read and observe the introductory information and safety warnings →

ꢀ

Introduction

Function

26/32

Volkswagen information system -> Driving data for Your Volkswagen Polo SUV Fourth Generation (2001-2009)

Related Topics

Volkswagen information system

Popular Owner Manuals

Latest Owner Manuals