Advertisement

Advertisement

Lighting, windscreen wipers and washers -> Function COMING HOME, LEAVING HOME for Your Volkswagen T Cross SUV First Generation (2018-2025)

When the parking light is switched on, an acoustic  
warning signal sounds and the driver's door is  
opened. After a few seconds or after the driver's  
door is closed, the warning signal will stop.  
Parking light function  
Usage  
Double-sided parking light  
The two-sided parking light allows the parked vehi-  
cle to be illuminated through activation of the side-  
lights.  
CORNER function  
Functionality  
One-sided parking light  
The one-sided parking light allows one side of the  
parked vehicle to be illuminated through activation  
of the corresponding sidelights.  
The CORNER function is intended for turning or ma-  
noeuvring (e.g. when parking).  
The function illuminates the vicinity of the vehicle  
front in the direction of travel.  
Operation  
Operating conditions  
Double-sided parking light  
— Turn on the ignition.  
The turn signal is switched on or the front  
wheels are steered sharply.  
— Turn the light switch to position  
— Switch off the ignition.  
— Lock the vehicle.  
.
The low beam is switched on.  
The fog lights are not switched on.  
The driving speed is lower than 40 km/h.  
When the parking light is switched on, an acoustic  
warning signal sounds after the ignition is switched  
off and the driver's door is opened. After a few sec-  
onds or after the driver's door is closed, the warning  
signal will stop.  
Function COMING HOME,  
LEAVING HOME  
The light may switch off automatically if the 12-volt  
vehicle battery is too low. If the parking lights on  
both sides are switched on with the ignition off, the  
lights will not be switched off automatically and the  
12 volt vehicle battery may be discharged.  
Functionality  
Version 1  
One-sided parking light  
Applies to vehicles with the function of the automat-  
ic driving light switch.  
The COMING HOME function turns on the light after  
turning off the ignition and opening the driver's  
door. The light switches off automatically after the  
set lighting time has elapsed.  
The LEAVING HOME function switches on the light  
when unlocking the vehicle with the wireless remote  
control.  
Version 2  
Applies to vehicles without the function of the auto-  
matic driving light switch.  
A
B
Switch on the sidelights on the right  
Switch on the sidelights on the left  
The COMING HOME function turns on the light after  
turning off the ignition and opening the driver's  
door. The light switches off automatically after the  
set lighting time has elapsed.  
— Switch off the ignition.  
— Move the lever to the appropriate position.  
— Lock the vehicle.  
Parking light function  
47  
The LEAVING HOME function switches on the light  
when unlocking the vehicle with the wireless remote  
control.  
After changing a bulb in the low beam light, the  
main beam or fog light, have the headlights adjusted  
by a specialist garage.  
CAUTION  
Halogen lamps are pressurised and can burst dur-  
ing replacement!  
Operating conditions  
Wear gloves and safety goggles.  
·
Version 1  
Applies to vehicles with the function of the automat-  
ic driving light switch.  
NOTICE  
Contamination of the halogen lamp reduces the life  
of the lamp!  
Visibility has worsened.  
The light switch is in the  
position.  
Do not touch the glass of the light bulb with your  
·
bare fingers.  
Version 2  
NOTICE  
Applies to vehicles without the function of the auto-  
matic driving light switch.  
Danger of headlight damage due to the ingress of  
water and dirt!  
The light switch is in the position.  
Always fit the protective cap on the headlight  
correctly after changing a bulb.  
·
Operation  
Conditions for changing a bulb  
function COMING HOME activate manually  
Applies to vehicles without the function of the auto-  
matic driving light switch.  
Ignition off  
Light switched off  
— Switch off the ignition.  
— Switch off the ignition and briefly hold the left  
lever under the steering wheel in position  
(switching on the headlight flasher).  
Low beam  
— Open the driver door.  
Removing the defective light bulb  
Settings  
This function is set in the following menu in the In-  
fotainment system:  
Applies to 10 infotainment:  
Car Lights settings  
Replace light bulbs  
The headlight on the left  
What you should be mindful of  
— Remove the protective cap from the headlight.  
DIY replacement of the following bulbs is possible.  
Have the remaining light sources replaced by a spe-  
cialist garage.  
The new bulb must conform to the specification of  
the original light bulb. The name of the bulb is  
marked on the bulb socket.  
48  
Lighting, windscreen wipers and washers