Advertisement

Advertisement

Driving on slopes -> Hill start assist for Your Volkswagen Taos SUV First Generation (2022-2025)

Vehicle is not moving even when a drive gear is engaged  
If the vehicle does not move in the desired direction, the system may not have engaged the drive position correctly.  
1. Press the brake pedal and select the drive position again.  
2. If the vehicle still does not move in the desired direction, there is a system malfunction. See an authorized Volkswagen  
dealer or authorized Volkswagen Service Facility for assistance to have the system checked.  
WARNING  
If the parking lock is released and the electronic parking brake is switched off, the vehicle may start to move  
unexpectedly on inclines or hills. This can cause accidents and serious injuries.  
Never release the parking lock once the electronic parking brake is switched off.  
NOTICE  
If the vehicle rolls with the engine off and the selector lever in position  
DSG® automated transmission will be damaged.  
for a long period of time or at high speed, the  
Do not allow the vehicle to roll for a long period of time or at high speed with the engine off and in the  
the case of towing.  
gear, e.g. in  
NOTICE  
If the transmission gets too hot or overheats, this may lead to increased wear or damage to the component.  
Drive faster than approx. 20 km/h (approx. 12 mph) or immediately stop the vehicle safely the first time the vehicle  
indicates that the transmission is overheating.  
Stop the vehicle safely as soon as possible and switch off the engine if the message and audible warning are  
repeating approximately every 10 seconds.  
Let the transmission cool down.  
Only start driving again when the audible warning is no longer sounding.  
Avoid starting the vehicle and driving slowly, like at walking speed, while the transmission is overheated.  
Driving on slopes  
Hill start assist  
Hill start assist helps when starting to  
drive uphill by actively holding the  
vehicle in place.  
Functional requirements  
The following requirements must be met at the same time:  
The vehicle must be stationary and held with the brake pedal until you start driving.  
The engine must be running “evenly”.  
A gear or a position is engaged for driving uphill.  
To start driving, take your foot off the brake pedal and press the accelerator pedal immediately. The brakes will release  
191  
gradually as you start driving.  
The holding function of the Hill Start Assist remains active only for a short time. Drive off within approx. two seconds.  
When is it active?  
Hill Start Assist is immediately deactivated if one of the conditions specified below in is no longer met:  
The driver’s door is opened.  
If the engine is running “unevenly” or in the event of an engine fault.  
The engine is switched off or it stalls.  
The selector lever is in the neutral position  
.
CAUTION  
If you do not pull away immediately after releasing the brake pedal, the vehicle may roll backward under certain  
circumstances. This can cause injuries or damage to objects.  
If this is the case, press the brake pedal or set the electronic parking brake immediately.  
Press the brake pedal for a few seconds before you start to drive if you are driving on an incline in heavy traffic and  
you would like to prevent the vehicle from rolling backwards when starting to drive.  
Downhill speed control  
Downhill speed control helps the driver  
when traveling on slopes.  
System function  
The DSG® automated transmission selects the optimum gear itself, depending on the present gradient and current speed.  
The selector lever must be in the  
selector lever position. Downhill speed control is not active in Tiptronic mode.  
As the downhill speed control can only downshift as far as third gear, you may need to switch to Tiptronic mode on very steep  
downhill stretches. In Tiptronic mode, manually shift into second or first gear to use the engine's braking efficiency and reduce  
the load on the brakes.  
While downhill speed control is active, the start-stop system is automatically deactivated.  
Automatically activating downhill speed control  
If the gradient is greater than approximately 6%.  
And: if the selector lever is in the  
selector lever position.  
In addition, if the cruise control system (CCS ) is switched off: if the speed is slower than approx. 80 km/h (approx.  
50 mph).  
Or: The brake is pressed.  
If the cruise control system (CCS) is also active: if the saved speed is exceeded.  
In addition, if Adaptive Cruise Control (ACC) is switched off: if the speed is slower than approx. 80 km/h (approx.  
50 mph).  
Or: The brake is pressed.  
If the Adaptive Cruise Control (ACC) is also active: if the saved speed is exceeded.  
Downhill speed control deactivates automatically  
192