Emergency starting and starting the engine with a very weak vehicle battery or after the vehicle
battery has been replaced may change or delete system settings (including time, date, personal con-
venience settings and programming). Check the settings and correct as necessary once the vehicle
battery has built up a sufficient charge.
Using the instrument cluster menus: Basic version
Fig. 16 Basic version (vehicles without menu control multi-function steering wheel): Control buttons 1 and 2
on the windshield wiper lever.
ꢀ Please first read and note the introductory information and heed the WARNINGS
In the Basic version, the instrument cluster displays are controlled by the OK/RESET button and the
TRIP rocker switch on the windshield wiper lever (⇒ꢀfig. 16 (1) and (2)).
Switch on the ignition. The instrument cluster display is divided into 3 parts. The time (digital clock) is
displayed in the top part. The bottom part contains the odometer and the trip odometer “trip”. The
display in the middle part is selected by pushing the TRIP rocker switch (2) on the end of the wind-
shield wiper lever.
The available displays are as follows:
Fuel range estimate ꢀ (estimated distance you can drive with the fuel remaining in the tank).
Trip memory 1 (single trip memory) and trip memory 2 (total trip memory).
▪
Push the OK/RESET button (1) on the windshield wiper lever to toggle between trip memories 1
and 2.
▪
▪
Push and hold the OK/RESET button to reset a trip memory to 0.
The function of the 2 trip memories is explained in ⇒ꢀ MFI menu (Multi-Function Indicator): Premi-
um version. The 2 trip memories are in addition to the trip odometer, which is displayed in the bot-
tom part of the instrument cluster and controlled using the 0.0/SET button on the right of the in-
strument panel ⇒ꢀfig. 11, ⇒ꢀfig. 12.
ø --- mph (ø --- km/h) shows the average speed on trips per trip memories 1 and 2.
▪
Push the OK/RESET button on the windshield wiper lever to toggle between the 2 average speed
figures.
ꢀ--- mph (ꢁ--- km/h) or xx mph (xx km/h). Use this menu to set or disable the speed warning
feature.
▪
Push the OK/RESET button to toggle between --- mph (--- km/h) (speed warning disabled) and xx
mph (xx km/h).
▪
▪
▪
A warning chime will sound you if you reach the set speed; there may also be a visual message.
The set speed will blink for a few seconds after you toggle to xx mph (xx km/h).
Press the TRIP rocker switch (2) while the set speed is flashing to increase or decrease the speed.
English 
