The chassis dimensions can be taken from the following drawings
(see p. 20-23). Chassis drawings, on a scale of
1:20
and
1:10, are available to
help you planning the attachment.
If reinforced springs, enhanced springs are installed or if tyre
sizes are used that are differing from the standard model,
vehicle and frame heights (as measured from ground level) may
change considerably. In this case, it is necessary to
consider this equipment during projecting.
Important note
• The minimum distance between cab and attachment must be at least
30 mm.
• The rear overhang of the attachments must not exceed 40% of the
wheel base.
The maximum
permitted overhang (rear) of 40% of the wheel base, results in the following max. external
attachment
lengths for chassis. These values must not be exceeded:
Standard attachment max. external attachment
Wheelbase length, interior
length, 40% overhang
Chassis with
driver™s cab
2.920 mm 2.505 mm
2.686 mm
Chassis with
driver™s cab
3.320 mm 2.905 mm
3.320 mm 2.140 mm
3.246 mm
2.476 mm
Chassis with
double cab
Attachment
width:
The exterior width of the driver™s cab is 1,840 mm. If the
standard exterior mirrors are used, the attachment width must
not exceed 2,200 mm.
Note: Subject to errors and technical amendments. The electronic
version of the body guidelines is the decisive source of up-to-date data on body guidelines
(online body
guidelines). Data status August 2007
16
English 
