Advertisement

Advertisement

Maintenance -> Preparing the vehicle for working in the engine compartment for Your Volkswagen Transporter Van Seventh Generation (2021-2025)

Always disconnect the 12-volt vehicle battery. Ensure that the vehicle is unlocked when the 12-volt vehicle  
battery is disconnected as otherwise the anti-theft alarm will be activated.  
Never work in the direct proximity of heating systems, water heaters or any other naked flames.  
Always have a fully functional and tested fire extinguisher to hand.  
NOTICE  
The use of incorrect service fluids could result in serious malfunctions and engine damage.  
When refilling or replacing service fluids, ensure that you pour the correct service fluids into the correct openings.  
Service fluids leaks are harmful to the environment. For this reason, you should regularly check the ground  
underneath your vehicle. If there are patches of oil or other fluids on the ground, the vehicle should be  
inspected by a correspondingly qualified workshop. Any spilt service fluids must be disposed of properly.  
Preparing the vehicle for working in the engine compartment  
The following steps should always be carried out in the specified order before working in the engine compartment→  
:
1. Park the vehicle on a level and stable surface.  
2. Depress and hold the brake pedal until the engine has stopped.  
3. Move the selector lever to positionP .  
4. Switch on the electronic parking brake .  
5. Switch off the ignition (→ Switching off the engine).  
6. If necessary, remove the vehicle key from the vehicle and keep it in a separate location so that the vehicle  
cannot be started accidentally.  
7. Allow the engine to cool sufficiently.  
8. Children and other people should be kept well away from the engine compartment.  
9. Ensure that the vehicle cannot roll away unexpectedly.  
WARNING  
The items in these instructions are important for your own safety. Ignoring them can lead to severe injuries.  
Always comply with the instructions and observe generally valid safety precautions.  
492  
Opening and closing the bonnet  
Fig. 1 In the left-hand footwell: Bonnet release lever  
(illustration).  
Fig. 2 Above the radiator grille: Bonnet control lever  
(illustration).  
Opening the bonnet  
1. Ensure that the wiper arms are positioned on the windscreen before opening the bonnet→  
2. Pull the release lever in the direction of the arrow→ Fig. 1.  
.
The bonnet is released from the lock carrier catch by spring force→  
.
3. To open the bonnet completely, lift the bonnet slightly and simultaneously press the control lever in the  
direction of the arrow → Fig. 2.  
The gas strut holds the bonnet in the open position.  
Closing the bonnet  
1. Pull the bonnet down→  
.
2. Guide the bonnet gently into the bracket from a height of about 20 cm –do not press it down!  
If the bonnet has not closed, open it and then close it correctly.  
The bonnet is flush with the body parts around it when it is closed properly.  
WARNING  
493