Advertisement

Advertisement

Starting and driving -> Starting issues for Your Volkswagen Virtus 4 Door First Generation (2018-2023)

Starting a vehicle with automatic gearbox  
1. Secure the vehicle with the parking brake.  
2. Keep the brake pedal depressed.  
2. If the engine does not start, seek assistance  
from a specialist garage.  
The key cannot be turned in the ignition  
3. Move the selector lever to position or  
4. Press the starter button.  
.
— Move the steering wheel back and forth while  
turning the key.  
Starting is not possible with the starter button, the  
system did not detect the key  
CAUTION  
Danger of unexpected vehicle movement!  
illuminated  
At temperatures below -10°C, start the vehicle  
with the selector lever in the position.  
·
Stopping the engine  
1. Secure the vehicle with the parking brake.  
2. Press the starter button.  
WARNING  
Steering lock hazard!  
If the vehicle is moving with the engine off, e.g.  
when towing, switch on the ignition.  
·
NOTICE  
1. Put the key on the plastic cover under the right  
control lever.  
Risk of engine overheating!  
2. Press the starter button.  
Do not switch the engine off immediately at the  
·
end of your journey after the engine has been  
running at high loads. Leave it to run at an idling  
speed for about 1 minute.  
3. If the engine does not start, seek assistance  
from a specialist garage.  
The key might not be detected if the battery  
in the key is nearly discharged or the signal is  
faulty.  
Starting issues  
The engine cannot be turned off with the starter  
button  
Troubleshooting  
— Hold the starter button or press it twice.  
NOTICE  
The radiator fan keeps running even after the en-  
gine has stopped  
Risk of damage to the engine  
The radiator fan may continue to run for approxi-  
mately 10 minutes after the engine stops. This is not  
a fault.  
Do not start the vehicle by towing.  
·
The engine does not start  
The engine makes noises after a cold start  
1. Switch off the ignition.  
The increased running noise is due to the briefly in-  
creased engine speed. This is not a fault.  
2. Wait 30 seconds and repeat the starting proce-  
dure.  
3. If the engine does not start, use the jump start  
leads with the 12V vehicle battery of another  
vehicle » page 107 or seek assistance from  
a specialist garage.  
START STOP  
The engine does not start, the screen shows a mes-  
sage about the immobiliser  
Use  
The START-STOP system reduces the CO2 emissions  
and saves fuel.  
1. Use the other vehicle key.  
Starting issues  
85