Audi A1 2011 ➤ , Audi A1 Sportback 2018 ➤ , Audi A2 2001 ➤ , Audi A3 20 ...
Electrical Equipment General Information - Edition 08.2019
Version 1
– Release securing tabs in direction of -arrows- and then release
retainer clips -1 and 3 through 5-.
– Remove the retainer from the connectors -2-.
Version 2
– First release securing tabs in direction of -arrows- and then
retaining clips -1, 2, 3, 4, 6, and 7-.
– Remove the retainer from the multi-pin connector -5-.
Installing
Install in reverse order of removal. Note the following:
Note
Make sure the O-rings -1 and 3- are not damaged.
– Slide the connectors -4- into the retainer -2- until they click into
place.
2.2
Trailer Hitch Socket, Removing and In‐
stalling - Version 2
Removing
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
During installation, install the cable ties at the same location.
– Turn off the ignition and remove the key.
– Unfold and engage the trailer hitch.
– Cut the cable tie -1- and remove the screws -2 and 4-.
– Press the socket out of trailer hitch -3- in direction of -arrow-.
90
Rep. Gr.96 - Interior Lights, Lamps and Switches
English 
