Phone
Phone
Note
Read the information about Audi connect, es-
pecially regarding connectivity costs ð in
General information on page 187.
Introduction
Applies to: vehicles with phone
You can operate various phone functions easily
through the MMI in your vehicle.
Tips
Depending on the country and the vehicle equip-
ment, the following options may be available:
– The Bluetooth connection range is limited
to inside the vehicle.
– Connecting a mobile phone with Bluetooth
– Using two phones
– A selection of supported Bluetooth devices
can be found in the database for tested mo-
– Using the Audi phone box
WARNING
Setup
– Medical experts warn that mobile devices
can interfere with the function of pacemak-
ers. Always maintain a minimum distance of
about 7.9 inches (20 cm) between the mo-
bile device antennas and the pacemaker.
Connecting a mobile phone using
Bluetooth
Applies to: vehicles with phone
Requirement: the vehicle must be stationary and
the ignition must be turned on. The Bluetooth
settings must be open on your mobile device dur-
ing the connection setup. The mobile device to be
connected must not be actively connected to any
other Bluetooth device. The MMI must only be
connected to one mobile device.
– Do not carry the mobile device in a pocket
directly over the pacemaker when the
phone is turned on.
– Turn off the mobile device immediately if
you suspect it may be interfering with the
pacemaker.
– Do not use the voice recognition system*
ðpage 30 in emergencies because your
voice may change in stressful situations. The
system may take longer to dial the number
or may not be able to dial it at all. Dial the
emergency number manually.
►
Enable the Bluetooth function and visibility on
the MMI ðpage 231 and the mobile phone.
Applies to: MMI: Select on the home screen:
PHONE.
Follow the system instructions. The available
Bluetooth devices will be displayed after sever-
al seconds.
Press on the desired mobile device in the list of
displayed Bluetooth devices.
To update the list, press .
►
►
– Turn off your mobile device in areas where
there is a risk of an explosion. These loca-
tions are not always clearly marked. This
may include gas stations, fuel and chemical
storage facilities or transport vehicles, or lo-
cations where fuel vapors (such as propane
or gasoline vapor in vehicles or buildings),
chemicals or large quantities of dust parti-
cles (such as flour, sawdust or metal) may
be present in the air. This also applies to all
other locations where you would normally
turn off the vehicle engine.
►
►
A PIN for a secure Bluetooth connection will be
generated.
►
Confirm the PIN on your mobile device.
Follow the system instructions.
Pay attention to any other system prompts on
the MMI and on your mobile phone.
►
►
After connecting successfully
– The demands of traffic require full attention
of all road users. Always read the chapter
ðpage 23, Information about traffic safety.
The mobile phone contacts are automatically
loaded in the MMI. This process can take several
minutes, depending on the number of contacts.
175
English 
