Checking and topping up fluids
to draw current even when the ignition is off. If
the vehicle is left standing for long periods, this
can result in total 12-volt battery discharge. If
the vehicle battery is allowed to discharge com-
pletely, an internal chemical reaction damages
the battery irreparably. To avoid this, the battery
should be recharged at least once a month
ðpage 247. Please seek advice from a qualified
workshop.
part of the replacement procedure. Only
qualified workshops have the equipment re-
quired in order to perform the calibration
correctly. If the correct equipment is not
used, safety-related functions may fail – risk
of accident!
– Using a 12-volt vehicle battery that does not
have the same specifications or dimensions
as the factory-fitted 12-volt vehicle battery
can cause short-circuits or fires. Serious or
fatal injuries may occur as a result.
– Only maintenance-free and leak-proof 12-
volt vehicle batteries that have the same
specifications and dimensions as the facto-
ry-fitted 12-volt vehicle battery may be
used.
Winter conditions
Cold weather is very hard on the 12-volt vehicle
battery. For this reason, you should have the bat-
tery checked by a qualified workshop before the
start of winter.
Replacing the battery
The following description applies to the 12-volt
vehicle battery. Any work on the battery must al-
ways be carried out by a qualified workshop.
CAUTION
– If the car is left standing for long periods,
protect the 12-volt vehicle battery from
frost. The battery will be damaged irrepara-
bly if it is allowed to freeze ðpage 247,
Charging the 12-volt vehicle battery.
– Always have the 12-volt vehicle battery re-
placed by a qualified workshop because the
vehicle electronics must be calibrated as
part of the replacement procedure. Only
qualified workshops have the equipment re-
quired in order to perform the calibration
correctly.
The 12-volt vehicle battery has been developed
for use in its installation location and is equipped
with safety features. If a 12-volt vehicle battery
has to be replaced, please enquire about the
electromagnetic compatibility, capacity and the
required maintenance, performance and safety
features of the new 12-volt vehicle battery be-
fore purchasing it from your qualified workshop.
The gas vent on the 12-volt vehicle battery must
always be located on the side of the negative ter-
minal. The gas vent on the side of the positive
terminal must always be sealed.
– If a battery is used that does not meet the
quality specifications set by Audi, or that
has a battery capacity that is too low, the
vehicle’s certification for use on public roads
is void and thus also the vehicle’s registra-
When replacing the 12-volt lead battery, use only
maintenance-free 12-volt lead batteries to
standards TL 825 06 and VW 7 50 73. These
standards must be from October 2014 or later.
tion ð
.
For the sake of the environment
WARNING
Batteries and electric/electronic equip-
ment must be disposed of appropriately
ðpage 290, Information on waste disposal.
– Any work on the batteries and electrical sys-
tem in your vehicle entails a risk of injury
and chemical burns in addition to danger of
accident or fire. For this reason, you must
have the work carried out by a qualified
workshop.
– Always have the 12-volt vehicle battery re-
placed by a qualified workshop because the
vehicle electronics must be calibrated as
246