Checking and topping up fluids
be able to operate, e.g. if the vehicle is continu-
ously used only for short trips, the filter will be-
come obstructed with soot and a driver message
will appear. The particulate filter requires clean-
ing (regeneration).
driving at a constant speed is the correct meth-
od for your vehicle (based on the engine) ð
.
The engine must be warmed up prior to the re-
generation trip.
►
Drive at a speed of between 50 km/h and
Driver messages:
120 km/h ð
. As a result of the increase in
Particulate filter: can be cleaned by driving
temperature, the soot in the filter will be
burned off.
Do not stop the regeneration trip until the indi-
cator lamp goes out.
vehicle. You can continue driving. See owner's
manual
►
Or
This procedure causes the particulate filter to re-
generate itself and may take some time (approx.
30 minutes).
Particulate filter: can be cleaned by driving
vehicle. You can continue driving. See owner's
manual
If the indicator lamp does not go out, drive to a
qualified workshop and have the fault rectified.
Different regeneration procedures are required,
depending on the type of engine (petrol or die-
sel).
Information on the particulate filter
As a result of the high temperatures which occur
during the regeneration of the particulate filter,
the radiator fan may continue to run after the en-
gine is switched off, even if the engine has not
yet reached operating temperature.
Regenerating the particulate filter by driving
and coasting
Applies to: vehicles with petrol engine
Before starting the regeneration trip, check
whether regenerating the particulate filter by
driving and coasting is the correct method for
Applies to vehicles with diesel engine: If the indi-
cator lamp requesting you to refuel the vehicle
also appears in the instrument cluster during
the regeneration trip, the particulate filter regen-
eration process may be interrupted. Drive to a
filling station and then resume the regeneration
trip after refuelling the vehicle.
your vehicle (based on the engine) ð
.
The engine must be warmed up prior to the re-
generation trip.
►
Drive at a speed of at least 80 km/h ð
.
►
Then take your foot off the accelerator com-
pletely for a few seconds and let the vehicle
coast in gear.
To maximise the service life of the particulate fil-
ter, always use suitable engine oil and the correct
fuel. You should also avoid driving the vehicle
continuously on short trips.
►
Repeat this procedure (accelerate to at least
80 km/h and coast again) until the indicator
lamp goes out.
This procedure causes the particulate filter to re-
generate itself and may take some time.
WARNING
It is essential, when regenerating the particu-
late filter, that you adjust your speed to suit
the weather, road, terrain and traffic condi-
tions. The recommendation must never lead
to the driver disregarding local traffic regula-
tions.
If the indicator lamp does not disappear after a
while, drive to a qualified workshop and have the
fault rectified.
Regenerating the particulate filter by driving
at a constant speed
Applies to: vehicles with diesel engine
CAUTION
Before starting the regeneration trip, check
whether regenerating the particulate filter by
Before starting the regeneration trip, check
which method (driving at a constant speed or
234