Controls and features -> Transporting children safely for Your BMW Z8 Roadster First Generation (2000-2003)

Airbags  
Transporting children safely  
53n  
Before installing any child-  
restraint device or child seat,  
please read the following:  
In the interest of the child's safety,  
please carefully read and comply with  
the instructions for installation and use  
provided by the child restraint's manu-  
facturer whenever you use such a  
device.  
Never install a rear-facing child-  
restraint system in the passenger seat  
of this vehicle.  
If the airbag deploys and hits the back- Do not allow children to lean out of a  
rest of the rear-facing child seat, it is  
likely that the child sitting in the rear-  
facing child seat will be seriously  
injured or killed.  
child-restraint system toward the door  
or dashboard, as otherwise serious  
injuries may result if the airbag deploys.  
Always ensure that all occupants (of all  
ages) remain properly and securely  
restrained at all times.  
If it is necessary for a child (not an  
infant) to ride in the vehicle, certain  
precautions should be taken. First,  
move the passenger seat as far away  
from the dashboard as possible. This  
important precaution is intended to  
maximize the distance between the  
airbag and the child. Older children  
should be tightly secured with the  
safety belt. Younger children should be  
secured in an appropriate forward-  
facing child-restraint system that has  
first been secured with a safety belt.  
The illustration shows the correct  
seating position for an older child  
wearing a safety belt with sufficient  
distance between the child and the side  
airbag (arrow).  
Read carefully and comply with the  
safety precautions covering safety belts  
on page 50. If you do not, the protec-  
tive function of the safety belts will be  
limited.<  
54nTransporting children safely  
To lock the belt  
Extract the entire length of the belt from  
the inertia reel mechanism. Allow the  
reel to retract the belt somewhat and  
engage the buckle, then tighten the belt  
against the child-restraint system. The  
retraction mechanism is now locked.  
The belt cannot be retracted further.  
Comply with the installation instructions  
provided by the manufacturer of the  
child-restraint system.  
To release the belt  
Child seat security  
Release the buckle, remove the child-  
restraint system and allow the inertia  
reel to retract the belt completely.  
The safety belt on the passenger side  
can be locked for mounting and  
securing child-restraint systems.  
A label with operating instructions is  
attached to the belt next to the sliding  
latch plate.