ACCESSES for Your Citroen Berlingo SUV First Generation (1996-2008)

Accesses  
Central locking  
Press this button to lock the  
vehicle completely.  
The direction indicators flash once.  
If one of the doors is open  
(transportation of long loads) or is not  
closed correctly, the central locking will  
not work.  
Deadlocking  
A second press on the closed padlock  
on the remote control within five  
seconds after locking changes the  
locking to deadlocking.  
This is confirmed by fixed lighting  
of the direction indicators for  
approximately two seconds.  
Deadlocking renders the exterior  
and interior door opening handles  
inoperative: do not leave anyone inside  
the vehicle when it is deadlocked.  
If deadlocking is activated from inside  
the vehicle using the remote control, it  
will change to normal locking when the  
vehicle is started.  
ACCESSES  
KEY  
Unlocking the load space  
Press this button to unlock all  
of the rear doors.  
This locks and unlocks the locks on the  
vehicle and starts the engine.  
Security of use  
To unlock the load space only:  
REMOTE CONTROL  
Unlocking  
Press this button once to  
unlock the front doors.  
Press this button again  
to unlock your vehicle  
completely.  
Press this control to lock the  
vehicle completely.  
Press this control to unlock  
the load space, the front  
doors alone remain locked.  
The direction indicators flash twice.  
2
Accesses  
Folding/unfolding the key  
Press this button to release  
the key from its housing.  
To fold the key, press this  
chromed button then fold  
the key into the housing.  
If you do not press the button, the  
mechanism may be damaged.  
Good practice  
Take care not to allow the remote  
control to come into contact with  
grease, dust, rain or a damp  
environment.  
A heavy object attached to the key  
(keyring, ...) weighing on the shaft of  
the key in the switch, may cause a  
malfunction.  
Programming the remote  
control  
Following changing of the remote  
control battery or disconnection of the  
vehicle battery, the remote control may  
have to be reprogrammed.  
Wait at least one minute before using  
the remote control.  
Insert the key in the ignition switch with  
the buttons (padlocks) of the remote  
control facing you.  
Use only identical batteries or  
batteries of an equivalent type to those  
recommended by CITROËN dealers.  
Do not discard the remote control  
batteries, they contain metals which  
are harmful to the environment.  
Deposit them at a CITROËN  
dealership, or at any other approved  
collection point.  
REMOTE CONTROL  
Changing the battery  
Battery ref.: CR1620/3 volts.  
The information "battery flat" is given  
by an audible signal, accompanied by  
a message on the display.  
To replace the battery, unclip the  
casing using a coin at the ring.  
If the remote control does not work  
after the battery has been changed,  
reprogramme the remote control.  
There is a risk of damage if the  
replacement battery does not conform.  
Switch on the ignition.  
Press the locking padlock for at least  
five seconds within the next ten  
seconds.  
Switch off the ignition.  
Wait at least one minute before using  
the remote control.  
The remote control is now working  
again.  
Accesses  
ELECTRONIC IMMOBILISER  
All of the keys contain an electronic  
immobiliser device.  
This device locks the engine supply  
system. It is activated automatically  
when the key is removed from the  
ignition.  
After the ignition is switched on, a  
dialogue is established between the  
key and the electronic immobiliser  
system.  
The remote control does not operate  
while the key is in the ignition, even if  
the ignition is off.  
As a safety precaution (with children  
on board), remove the key from the  
ignition when leaving the vehicle, even  
for a short time.  
The metal part of the key must be  
unfolded correctly for correct dialogue  
to take place.  
ALARM  
If fitted on your vehicle, this provides  
two types of protection:  
-
exterior protection: it sounds if a  
front/rear door or the bonnet is  
opened.  
interior protection: it sounds if  
the volume inside the passenger  
compartment changes (breaking  
of a window or a movement inside  
the vehicle).  
If you lose your keys  
When purchasing a second-hand  
vehicle:  
Visit a CITROËN dealer with the  
vehicle’s V5 registration document and  
your identification document.  
A CITROËN dealer will be able  
to retrieve the key code and  
the transponder code so that a  
replacement key can be ordered.  
-
have the keys memorised by a  
CITROËN dealer to ensure that  
the keys in your possession are  
the only ones which can start the  
vehicle.  
-
If your vehicle is fitted with a separation  
partition, the interior protection is not  
active in the load space.  
Good practice  
Do not make any modifications to the  
electronic immobiliser system.  
Operating the remote control, even  
when it is in your pocket, may result in  
involuntary unlocking of the doors.  
The simultaneous use of other  
high frequency equipment (mobile  
telephones, domestic alarms…), may  
interfere with the operation of the  
remote control temporarily.  
Locking the vehicle with  
complete alarm  
Setting the alarm  
-
Switch off the ignition and get out of  
the vehicle.  
-
Set the alarm within five minutes of  
getting out of the vehicle, by locking  
or deadlocking using the remote  
control. The red diode, located  
on the button, flashes once per  
second.  
2
Accesses  
Disarming  
Locking the vehicle without  
alarm  
-
Unlock the vehicle with the remote  
control or switch on the ignition, the  
red diode goes out.  
-
Insert the key in the lock on the  
driver’s door and lock it.  
Do not set the alarm when washing  
your vehicle.  
Locking the vehicle with  
exterior protection only  
Failure of the remote control  
When the alarm is set but the remote  
control does not operate:  
If, while you are away from the vehicle,  
you wish to leave a window partially  
open or a pet inside the vehicle, you  
should choose exterior protection only.  
-
Unlock the doors with the key and  
open the door. The alarm is triggered.  
-
Switch off the ignition.  
-
Switch on the ignition in the  
next ten seconds. The alarm is  
disarmed.  
FRONT DOORS  
From the outside  
-
In the next ten seconds,  
Use the remote control to lock/unlock  
the vehicle.  
Insert the metal part of the key in the  
lock on the driver’s side if the remote  
control does not work.  
press the button until  
the red diode is on  
continuously.  
Incorrect operation  
When the ignition is switched on, if the  
red diode remains on for ten seconds,  
there is a fault in the siren connection.  
Contact a CITROËN dealer to have the  
system checked.  
-
Get out of the vehicle.  
-
Within the next five minutes, set  
the alarm by locking or deadlocking  
using the remote control (the red  
diode flashes once a second).  
Automatic setting of the alarm  
Depending on the country in which  
the vehicle is sold, the alarm is set  
automatically approximately 2 minutes  
after the last door is closed.  
Triggering  
The siren sounds, the direction indicators  
flash for approximately 30 seconds and  
the red diode flashes rapidly.  
To prevent triggering of the alarm when  
a door is opened, it is imperative to  
press the remote control unlocking  
button again.  
-
To switch it off, insert the key and  
switch on the ignition.  
When the alarm has been triggered ten  
times in succession (when triggered  
for the eleventh time) it is deactivated.  
Repeat the rules for setting the alarm.  
Do not make any modifications  
to the alarm system as this could  
cause faults.  
From the inside  
Use the door opening control to unlock  
and open the door concerned.  
Accesses  
From the outside  
From the inside  
Good practice  
Pull the handle towards you then  
towards the rear and open the side  
door, guiding the rearward sliding to  
beyond the point of resistance to hold  
it open.  
Unlock and open the side door using  
this handle, guiding the rearward  
sliding to the point of resistance. Pass  
this point to hold the door open.  
Take care not to block the guide space  
on the floor to allow the door to slide  
correctly.  
If your vehicle is parked on a slope,  
guide the sliding of the side door. In  
fact, the door could open or close more  
rapidly due to the slope of the ground  
and could cause injury.  
For safety and operation reasons, do  
not drive with the sliding side door  
open.  
2
Accesses  
Practice  
HINGED REAR DOORS  
It is possible to drive with the  
right-hand door open to make the  
transportation of long loads easier.  
The left-hand door is kept closed by  
the distinctive "yellow" lock, positioned  
at the base of the door. This closed  
door must not be used as a load  
retainer.  
Driving with the right-hand door open  
is a special dispensation. Comply with  
the usual safety indications to attract  
the attention of other drivers.  
The hinged rear doors are  
asymmetrical (2/3 - 1/3), with the  
smaller door on the right.  
Pull the lever to open the right-hand  
door.  
To close, start with the right-hand door  
then close the left-hand door.  
They are fitted with a central lock.  
With the roof rear flap, the rear  
bumper has been strengthened to  
serve as a footrest on accessing  
the vehicle.  
From outside  
To open, pull the handle towards you.  
Accesses  
Opening to approximately 180°  
From inside  
A check strap system permits extension Pull the handle towards you to open  
of the opening from approximately 90°  
to approximately 180°.  
the left-hand door.  
Pull the yellow control when the door  
is open.  
The check strap will re-attach  
automatically on closing.  
2
Accesses  
REAR ROOF FLAP  
This rear roof flap is only compatible  
with the hinged doors.  
To open the rear roof flap:  
-
lower the black paddle to secure  
the rear roof flap.  
The side supports can be used as  
hooking points.  
Securing the rear roof flap places it  
on the seal correctly and guarantees  
sealing without noise.  
-
-
raise the black paddle of the toggle,  
The rear bumper has been  
strengthened to serve as a  
footrest on entering the vehicle.  
relieve the toggle by pressing the  
rear roof flap (downwards) then  
release the hook,  
Support bar  
A support bar is provided for  
transporting long loads, after opening  
the rear roof flap.  
Fold back the support bar by lifting the  
lever.  
Support it to the door pillar.  
-
-
lift the rear roof flap,  
pass the point of resistance to  
secure the rear roof flap using the  
support struts.  
Never drive without the support  
bar in place.  
The rear doors only lock when the  
support bar is installed.  
When the rear roof flap is open, take  
care when driving where height is  
restricted.  
Never rest loads directly on the rear  
doors.  
Support the long loads to be  
transported, lift them and reposition the  
support bar with one hand.  
Ensure that it is secured correctly by  
pressing the handle downwards past  
the point of resistance and secure the  
loads firmly.  
To close the rear roof flap:  
-
check that the support bar is  
secured correctly,  
lower the rear roof flap,  
-
-
while pressing the rear roof flap  
(downwards), take hold of the two  
loops of the spring then place the  
hook in its housing,  
Comply with the usual indications, to  
attract the attention of other drivers.  
Accesses  
TAILGATE  
From outside  
From inside  
Emergency control  
In the event of a central unlocking  
operating fault, this permits unlocking  
of the tailgate from the inside.  
Tailgate screen  
Locking/unlocking is by means of the  
remote control.  
To open, press the control below the  
trim then raise the tailgate.  
The opening rear screen allows you to  
access the rear of the vehicle directly,  
without having to open the tailgate.  
Insert a small screwdriver in the  
opening, between the door and the  
floor. To unlock the lock, move the  
catch to the left then push the tailgate.  
A pull strap is available to close the  
tailgate in the high position.  
Guide the closing of the tailgate to the  
balance point of its travel then apply a  
final press on the tailgate to close it fully.  
Opening  
After unlocking the vehicle using the  
remote control or the key, press the  
control and raise the rear screen to  
open it.  
Closing  
Close the rear screen by pressing  
the centre of the glass until it is fully  
closed.  
The tailgate and tailgate screen cannot  
both be open at the same time, to  
prevent damage to the glass and the  
screen itself.  
2
Accesses  
Protection against attack  
Locking while driving  
When the vehicle moves off, as soon  
as you reach approximately 6 mph  
(10 km/h), the system locks the doors.  
A noise characteristic of central locking  
is heard. The diode on the control on the  
fascia central control panel comes on.  
During the journey, opening a door  
results in complete unlocking of the  
vehicle.  
In the event of a serious impact, the  
doors are unlocked automatically  
to permit access by the emergency  
services.  
CENTRAL LOCKING  
Cab and load space  
Activating/deactivating the function  
The control diode:  
-
flashes when the doors are locked with  
the vehicle stationary and the engine off,  
comes on when the doors are locked  
and from the time the ignition is  
switched on.  
With the ignition on, press  
and hold this button to  
activate or deactivate the  
function.  
An initial press permits  
-
central locking of the front  
and rear doors, when they  
are closed.  
A second press permits central  
unlocking of the vehicle.  
Door open warning light  
Load space  
The control is inactive when the vehicle  
has been locked using the remote  
control or the key from the outside.  
Press to lock/unlock the rear  
doors without changing the  
locking status of the cab.  
If this warning light comes on,  
check that all of your vehicle’s  
doors are closed correctly.  
The doors can still be opened  
from the inside.