ACCESSES -> Electronic Immobiliser for Your Citroen Berlingo SUV First Generation (1996-2008)

Accesses  
ELECTRONIC IMMOBILISER  
All of the keys contain an electronic  
immobiliser device.  
This device locks the engine supply  
system. It is activated automatically  
when the key is removed from the  
ignition.  
After the ignition is switched on, a  
dialogue is established between the  
key and the electronic immobiliser  
system.  
The remote control does not operate  
while the key is in the ignition, even if  
the ignition is off.  
As a safety precaution (with children  
on board), remove the key from the  
ignition when leaving the vehicle, even  
for a short time.  
The metal part of the key must be  
unfolded correctly for correct dialogue  
to take place.  
ALARM  
If fitted on your vehicle, this provides  
two types of protection:  
-
exterior protection: it sounds if a  
front/rear door or the bonnet is  
opened.  
interior protection: it sounds if  
the volume inside the passenger  
compartment changes (breaking  
of a window or a movement inside  
the vehicle).  
If you lose your keys  
When purchasing a second-hand  
vehicle:  
Visit a CITROËN dealer with the  
vehicle’s V5 registration document and  
your identification document.  
A CITROËN dealer will be able  
to retrieve the key code and  
the transponder code so that a  
replacement key can be ordered.  
-
have the keys memorised by a  
CITROËN dealer to ensure that  
the keys in your possession are  
the only ones which can start the  
vehicle.  
-
If your vehicle is fitted with a separation  
partition, the interior protection is not  
active in the load space.  
Good practice  
Do not make any modifications to the  
electronic immobiliser system.  
Operating the remote control, even  
when it is in your pocket, may result in  
involuntary unlocking of the doors.  
The simultaneous use of other  
high frequency equipment (mobile  
telephones, domestic alarms…), may  
interfere with the operation of the  
remote control temporarily.  
Locking the vehicle with  
complete alarm  
Setting the alarm  
-
Switch off the ignition and get out of  
the vehicle.  
-
Set the alarm within five minutes of  
getting out of the vehicle, by locking  
or deadlocking using the remote  
control. The red diode, located  
on the button, flashes once per  
second.  
2