Advertisement

Advertisement

READY TO GO -> Service indicator for Your Citroen Berlingo SUV Second Generation (2008-2018)

Instruments and controls  
More than 1 000 miles/km before the A few seconds after the ignition is  
SERVICE INDICATOR  
next service is due  
switched on, the oil level is displayed  
(depending on version), then the total  
distance recorder resumes normal  
operation and the spanner remains on.  
This indicates that a service should be  
carried out shortly.  
This programmes service intervals  
according to the use of the vehicle.  
Example: 4 800 miles/km remain  
before the next service is due. When  
the ignition is switched on and for a  
few seconds, the screen shows:  
Operation  
A few moments after the ignition  
has been switched on, the spanner  
indicating a service operation comes  
on; the display for the total distance  
recorder gives (in round figures) the  
distance remaining before the next  
service.  
The points at which a service is due  
are calculated from the last indicator  
zero reset.  
Service overdue  
Each time the ignition is  
switched on and for a few  
seconds, the spanner  
flashes and the excess  
distance is displayed.  
A few seconds after the ignition is  
switched on, the oil level is displayed  
(depending on version), then the total  
distance recorder resumes normal  
operation showing the total and trip  
distances.  
The point at which a service is due is  
determined by two parameters:  
With the engine running the spanner  
remains on until the service has been  
carried out.  
For BlueHDi Diesel versions, this  
alert is also accompanied by the fixed  
illumination of the Service warning  
lamp, on switching on the ignition.  
-
-
the distance travelled,  
the time which has elapsed since  
the last service.  
Less than 1 000 miles/km before the  
next service is due  
Each time the ignition is switched on and for a few  
seconds, the spanner flashes and the number of  
miles/kilometres remaining is displayed:  
The distance remaining before the  
next service may be weighted by  
the time factor, depending on the  
type of driving.  
For BlueHDi Diesel versions, the  
spanner can also come on early,  
according the level of deterioration  
of the engine oil. Deterioration of the  
engine oil depends on the conditions of  
use of the vehicle.  
3
Instruments and controls  
Zero reset  
Oil level  
correct  
Dipstick  
A = maximum, never exceed  
this level as a surplus of oil  
may damage the engine.  
Contact a CITROËN dealer  
or a qualified workshop  
without delay.  
B = minimum, top up the level  
via the oil filler cap, using the  
grade of oil suited to your  
engine.  
Your CITROËN dealer or a qualified  
workshop carries out this operation  
after each service.  
However, if you carry out the service  
yourself, the re-set procedure is as  
follows:  
Low oil level  
Flashing of "OIL",  
linked with the  
service warning lamp,  
-
-
switch off the ignition,  
press and hold the trip recorder  
reset button,  
switch on the ignition.  
accompanied by an  
audible signal and a message in the  
screen, indicates a low oil level which  
could damage the engine.  
-
The display begins a countdown.  
When the display shows "=0", release  
the button; the spanner disappears.  
If the low oil level is confirmed by a  
check using the dipstick, it is essential  
that the level is topped up.  
Trip recorder zero  
reset button  
With the ignition on, press  
the button until the zeros  
appear.  
Oil level gauge  
fault  
Flashing of "OIL--"  
indicates a  
malfunction of the  
After this operation, if you wish  
to disconnect the battery, lock  
the vehicle and wait for at least five  
minutes, otherwise the zero re-set will  
not be registered.  
engine oil level indicator. Contact  
a CITROËN dealer or a qualified  
workshop.  
Lighting dimmer  
The level read will only be correct  
if the vehicle is on level ground  
and the engine has been off for  
more than 30 minutes.  
Engine oil level indicator  
With the lighting on,  
press the button to vary  
Depending on your vehicle's engine,  
when the ignition is switched on,  
the engine oil level is indicated for  
a few seconds, after the service  
information.  
the brightness of the  
instruments and controls.  
When the lighting reaches  
the minimum  
(or maximum) setting, release the  
button then press it again to increase  
(or reduce) the brightness.  
As soon as the lighting is of the  
required brightness, release the button.