Instruments and controls
Zero reset
Oil level
correct
Dipstick
A = maximum, never exceed
this level as a surplus of oil
may damage the engine.
Contact a CITROËN dealer
or a qualified workshop
without delay.
B = minimum, top up the level
via the oil filler cap, using the
grade of oil suited to your
engine.
Your CITROËN dealer or a qualified
workshop carries out this operation
after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
Low oil level
Flashing of "OIL",
linked with the
service warning lamp,
-
-
switch off the ignition,
press and hold the trip recorder
reset button,
switch on the ignition.
accompanied by an
audible signal and a message in the
screen, indicates a low oil level which
could damage the engine.
-
The display begins a countdown.
When the display shows "=0", release
the button; the spanner disappears.
If the low oil level is confirmed by a
check using the dipstick, it is essential
that the level is topped up.
Trip recorder zero
reset button
With the ignition on, press
the button until the zeros
appear.
Oil level gauge
fault
Flashing of "OIL--"
indicates a
malfunction of the
After this operation, if you wish
to disconnect the battery, lock
the vehicle and wait for at least five
minutes, otherwise the zero re-set will
not be registered.
engine oil level indicator. Contact
a CITROËN dealer or a qualified
workshop.
Lighting dimmer
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 30 minutes.
Engine oil level indicator
With the lighting on,
press the button to vary
Depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
the brightness of the
instruments and controls.
When the lighting reaches
the minimum
(or maximum) setting, release the
button then press it again to increase
(or reduce) the brightness.
As soon as the lighting is of the
required brightness, release the button.
English 