Driving -> Stop & Start (Petrol) for Your Citroen C3 SUV Fourth Generation (2022-2025)

Driving  
Do not exceed 62 mph (100 km/h), local speed  
restrictions permitting.  
Operation  
Have the system checked by a CITROËN dealer.  
The information appears in the in-  
strument panel in the form of an as-  
cending or descending arrow.  
Warning  
There is a risk of damaging the  
gearbox:  
The number displayed is the current gear.  
Gear shift recommendations should not be  
considered compulsory. In fact, the road layout,  
the traffic density and safety remain the  
deciding factors when choosing the best  
gear. The driver therefore remains responsible  
for deciding whether or not to follow the  
indications issued by the system.  
– If the accelerator and brake pedals are  
depressed simultaneously.  
– In the event of a battery failure, forcing the  
selector from position P to another position.  
In this case, the following steps will allow you to  
take manually the gear selector out of mode P:  
Apply the parking brake.  
Warning  
Do not try to start the engine by  
pushing the vehicle.  
This system cannot be deactivated.  
Insert a flat tip screwdriver into the lower  
part of the gear selector plate to unclip its  
cover (take care not to scratch the plastic  
parts).  
Emergency unlocking of gear selector  
Tip  
With an automatic gearbox, the  
system is only active in manual operation.  
Vehicles with automatic gearbox are equipped  
with an electrically controlled parking lock  
system.  
The vehicle may be locked in Park mode or  
unable to switch from mode P to other modes:  
Remove the gear selector cover by pulling  
upwards.  
Tip  
Press the solenoid switch downwards and  
move the gear selector from P to N or to  
another mode.  
The system adapts the gear change  
instructions according to the driving  
conditions (e.g. slope, load) and driving style  
(e.g. power demand, acceleration, braking).  
The system never suggests:  
– engaging first gear.  
-
-
-
If the vehicle's battery is discharged.  
Or if another electrical fault occurs.  
Or if an accident occurs while the vehicle is  
in Park mode.  
Warning  
If you have any problems carrying out  
the procedure, contact a CITROËN dealer  
or a towing professional to have the vehicle  
towed.  
– engaging reverse gear.  
Hill start assist  
This system keeps your vehicle briefly  
Gear efficiency indicator  
This system helps reduce fuel consumption by  
recommending the most appropriate gear.  
stationary (for approximately 2 seconds) when  
making a hill start, while you transfer your foot  
from the brake pedal to the accelerator pedal.  
70  
Driving  
This system is only active when:  
-
If mode D or M is selected on an automatic  
gearbox.  
N
D
Neutral  
To move the vehicle with the ignition  
off and so allow it to free-wheel.  
6
-
The vehicle is completely stationary, with  
your foot on the brake pedal.  
-
-
Certain slope conditions are met.  
The driver’s door is closed.  
Drive (automatic forward gear)  
ECO ECO mode  
Warning  
Information displayed on  
the instrument panel  
Do not leave the vehicle while it is  
being held temporarily by hill start assist.  
If someone needs to get out of the vehicle  
with the engine running, apply the parking  
brake manually. Then check that the parking  
brake indicator lamp and the P indicator  
lamp in the electric parking brake control are  
on fixed.  
Facing downhill, with the vehicle stationary  
and reverse gear engaged, the vehicle is held  
for a short time when the driver releases the  
brake pedal.  
When the ignition is switched on, the drive  
selector status is displayed on the instrument  
panel:  
R : Reverse.  
N : Neutral.  
Drive selector (Electric)  
D : Drive (automatic forward gear).  
Warning  
Operation  
The hill start assist function cannot  
be deactivated. However, using the parking  
brake to immobilise the vehicle interrupts its  
operation.  
In mode N, with your foot on the brake  
pedal :  
• Move the drive selector forwards to select  
mode R.  
Operation  
• Move the drive selector backwards to select  
mode D.  
Release the selector fully after each push; it  
will then return to its initial position.  
The drive selector is a pulse selector with an  
ECO mode.  
The drive selector provides traction control  
based on the driving style, the road profile and  
the vehicle load.  
With ECO mode activated, it also manages  
acceleration force and allows regenerative  
braking.  
ECO mode  
ECO mode helps reducing power consumption  
by reducing acceleration when compared to  
the same accelerator pedal position in the D  
(Drive) position.  
Economy mode provides the best results  
regarding the range (distance) of the vehicle.  
Facing uphill, with the vehicle stationary, the  
vehicle is held for a short time when the driver  
releases the brake pedal:  
R
Reverse  
-
If first gear or neutral is engaged on a  
manual gearbox.  
To engage reverse gear, with your foot  
on the brake pedal.  
71