D R I V I N G
Reactivation
Operating fault
If during the operation of cruise
control, the system is unable to
keep within the memorised speed
(for example on a steep descent),
then the speed flashes. Adapt your
speed as necessary.
By recall of the memorised
speed
If there is a malfunction, a message
will display accompanied by an au-
dible signal and lighting of the serv-
ice warning lamp.
Have it checked by a CITROËN
dealer.
After a disengagement, press on
button 3. Your vehicle automati-
cally returns to the memorised
cruise speed which is displayed
in zone A.
If the memorised cruise speed
is higher than the current speed,
the vehicle will accelerate to
reach the former.
Return to normal driving
By selection of the current
speed
Cruise control should only
be used when the driving
conditions allow you to drive
at a constant speed.
Press on button 2 or 4 once the
desiredspeedhasbeenreached.
The information "OFF" will then
disappear from the instrument
panel display.
Do not use it in heavy traffic, or on
dangerous or slippery roads.
The driver must remain attentive
and in full control of his vehicle.
You are recommended to keep your
feet within range of the pedals.
Overriding the programmed
speed
IX
To avoid any risk of interfering with
the pedals:
During the operation of cruise con-
trol, it is always possible to use the
accelerator to go faster than the
cruise speed (for example to over-
take another vehicle). The speed
displayed in zone A flashes.
You have only to release the accel-
erator pedal to return to the cruise
speed.
By an action on the control 1 from
position "REG" to position 0.
By the engine stopping.
-
check that the floor mat is cor-
rectly positioned,
-
never use more than one floor
mat.
The cruise speed previously
chosen is no longer memorised.
Copyright CITRO
E
N compiled by C4owners.org 148
English 