Steering wheel controls
Exceeding the programmed speed
Switching the function off
Operating fault
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal firmly
beyond the point of resistance.
-
Place the dial in position 0 or switch off
the ignition to switch the system off.
The programmed speed is cleared then
replaced by three dashes.
The last programmed speed remains in the
memory.
Contact a CITROËN dealer to have the
system checked.
The limiter is deactivated temporarily and
the programmed speed flashes.
Good practice
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance and
responsibility on the part of the driver.
To return to the limiter function, reduce your
speed to below the programmed speed.
Always pay attention to the profile of the
road and sharp acceleration and stay in
complete control of your vehicle.
Flashing of the speed
The speed flashes:
To avoid any jamming under the pedals:
-
following forcing of the accelerator point
of resistance,
-
ensure that the mat and its fixings on the
floor are positioned correctly,
-
when the limiter cannot prevent an
-
never place one mat on top of another.
increase in the vehicle speed due to the
profile of the road or on a steep descent,
-
in the event of sharp acceleration.
English 