Instruments and controls
Zero re-set
Oil level correct
Lack of oil
Dipstick
A = maximum, never exceed
this level as a surplus of oil may
damage the engine.
Your CITROËN dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as follows:
Contact a CITROËN dealer
without delay.
-
-
switch off the ignition,
Flashing of "OIL", linked
with the service warning
light, accompanied by
B = minimum, top up the level via
the oil filler cap, using the type of
oil suited to your engine.
press and hold the trip recorder reset
button,
an audible signal and a
-
switch on the ignition.
message on the display, indicates a lack of
oil which could damage the engine.
The display begins a countdown.
When the display shows "=0", release the
If the lack of oil is confirmed by a check
using the dipstick, it is essential that the
level is topped up.
button; the spanner disappears.
Trip recorder zero reset
button
With the ignition on, press
the button until the zeros
appear.
Oil level gauge fault
Flashing of "OIL --"
indicates a malfunction
of the engine oil level
gauge. Consult a
After this operation, if you wish to
disconnect the battery, lock the vehicle
and wait for at least five minutes, otherwise
the zero re-set will not be registered.
Lighting rheostat
CITROËN dealer.
With the lights on, press the
button to vary the intensity of
the lighting of the instruments
The level read will only be correct if the
vehicle is on level ground and
the engine has been off for more than
15 minutes.
Engine oil level indicator
and controls. When the
lighting reaches the minimum (or maximum)
setting, release the button then press it
again to increase (or reduce) the brightness.
When the ignition is switched on, the engine
oil level is indicated for a few seconds, after
the service information.
As soon as the lighting is of the required
brightness, release the button.
English 