Advertisement

Advertisement

Ready to go -> Service indicator for Your Citroen Relay Van 2014-2024

Instruments and controls  
SErVIcE IndIcAtOr  
Engine oil level  
Engine oil condition  
Servicing information  
The warning lamp flashing and,  
if your vehicle has the function,  
a message displayed at every  
Depending on the engine, the engine oil  
level then appears, graduated from 1 (Min)  
to 5 (Max).  
For a few seconds after the ignition is  
switched on, the spanner symbolising service  
information comes on: the screen informs you  
when the next service is due, in accordance  
with the servicing schedule indicated in  
themanufacturer's service schedule.  
engine start: the system has  
If no graduation is displayed, the oil level is  
too low; you must top-up to avoid damaging  
the engine.  
detected deterioration of the engine oil.  
Have the oil changed as soon as possible.  
For the oil level reading to be accurate, the  
vehicle must be parked on level ground, with  
the engine off for more than 30 minutes.  
This 2nd warning lamp, coupled with  
the 1st, comes on in the instrument  
panel when the oil has not been  
changed and the deterioration of  
the oil has reached another threshold. If this  
warning comes on at regular intervals, have the  
oil changed as soon as possible.  
If in doubt, check the level with the dipstick.  
Refer to the "Checks - Levels and  
checks" section.  
For 3.0 litre HDi engines, the engine  
speed is restricted to 3 000 rpm, then  
1 500 rpm until the oil change is done.  
Have the engine oil changed to avoid  
any risk of damage.  
This information is determined in relation  
to the distance travelled since the previous  
service.  
After a few seconds, the display returns to  
its usual functions.  
Instruments and controls  
resetting the servicing information  
reminder of servicing information  
The continuous flashing of the indicator is  
stopped by a qualified workshop using a  
diagnostic tool, after each service.  
At any time, to access the service indicator,  
press briefly on the MOdE button.  
Use the up/down arrows to see the  
If you have carried out the service on your  
vehicle yourself, you can reset the service  
indicator as follows:  
scheduling and engine oil wear information.  
Pressing the MOdE button again allows you  
to return to the various display menus.  
F
F
F
insert the ignition key into the switch,  
A long press returns you to the main menu.  
turn it to the MAr position,  
simultaneously press the brake and  
accelerator pedals for more than  
15 seconds.  
Menu...  
choose... Allows you to...  
Display the  
Service  
Refer to the list of checks in the  
manufacturer's service schedule which  
was given to you on handover of the  
vehicle.  
distance  
(miles/  
remaining  
km before  
before the  
service)  
next service.  
11  
Service  
Display  
Oil (miles/  
the miles/  
km  
kilometres to  
before oil  
the next oil  
change)  
change.  
Refer to the "Technology on board -  
Vehicle configuration" section.  
2