2002-2008 Cupra Born SUV Seats and head restraints User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats and head restraints for Your Cupra Born SUV First Generation (2002-2008)

Frontseats
WARNING  
Manual adjustment of the front  
seats  
Seats and head re-  
straints  
Incorrectly using upholstery and seat cov-  
ers might cause an accidental activation of  
the electrical seat adjustment system and  
make it move unexpectedly while driving.  
This might cause loss of control of the vehi-  
cle and thus accidents or injuries. Moreover,  
the electrical components of the front seats  
might be damaged.  
Front seats  
Introduction  
WARNING  
●
Never attach or place seat upholstery or  
covers on the electric controls.  
Always read and observe the information and  
safety advice given in chapter ››› page 39,  
Correct sitting position of vehicle occu-  
pants.  
●
Never use upholstery or seat covers that  
have not been explicitly authorised for the  
seats of the vehicle.  
Fig. 95 Front seats: manual seat  
adjustment.  
WARNING  
NOTICE  
Incorrect seat adjustment may lead to acci-  
dents and severe injuries.  
Objects with sharp edges can damage the  
seats.  
1
Pull the lever to move the seat forwards  
or backwards. The seat must engage when  
the lever is released!  
●
Only adjust the seats when the vehicle  
●
Do not rub the seats with sharp objects.  
is stationary, as the seats could move unex-  
pectedly while the vehicle is in motion and  
you could lose control of the vehicle. Fur-  
thermore, an incorrect position is adopted  
when adjusting the seat.  
Sharp objects, such as zips and rivets on  
clothing or belts, can damage surfaces. Open  
Velcro fasteners can also cause damage.  
2
Lift the handle to move the seat cushion  
forwards or backwards1)  
.
3
Move the lever up or down to adjust the  
seat height; several times if necessary.  
●
Adjust the height, position and inclination  
of the front seats only when their movement  
area is empty.  
4
Without placing force on the seat back-  
rest, turn the wheel to adjust the backrest.  
●
●
Make sure there are no objects in that area.  
Make sure that the movement and locking  
areas of the seats are clean.  
1)  
Depending on the equipment, only in the case of power seats.  
107  
Seats and head restraints  
WARNING  
Electric adjustment of the front  
seats  
Rear seats  
If the electric front seats are used negligently  
or without paying due attention, it can cause  
serious injury.  
Folding down and raising the rear  
seat backrest  
●
The front seats can also be electrically  
adjusted when the ignition is switched oꢀ.  
Never leave a child or any other person who  
may need help in the vehicle.  
●
In the event of an emergency, electrical  
adjustment can be stopped by pressing any  
control.  
NOTICE  
To avoid damaging the electrical compo-  
nents of the seats, please refrain from kneel-  
ing on the seat or applying sharp pressure at  
a single point to the seat cushion and back-  
rest.  
Fig. 97 Rear seat: folding down the  
backrest.  
Fig. 96 Driver's seat: electric seat  
adjustment.  
The rear seat backrest is split and each part  
be lowered separately to extend the luggage  
compartment.  
A
Adjust the lumbar support: press the but-  
ton according to the desired position.  
Note  
●
It may not be possible to electrically adjust  
B
C
Seat forwards/backwards: press the button  
forwards/backwards.  
Seat up/down: Press the rear part of the  
button up/down. To adjust the angle of  
the seat cushion, press the front of the  
button up/down.  
the seat if the vehicle battery is very low.  
Folding the backrest forwards  
●
As soon as the vehicle is ready for driving,  
●
Fully lower the rear headrests ››› page 110.  
the power adjustment of seats is turned oꢀ.  
●
1
Press the unlock button ››› Fig. 97  
for-  
wards and at the same time fold the backrest  
down. The rear seat backrest is not engaged  
Backrest further upright/further reclined:  
press the button forwards/backwards.  
2
when the red marking of the button  
ble.  
is visi-  
108  
Headrest
When the rear seat backrest is lowered or is  
Correct adjustment of head restraint1)  
Converting the table to a seat  
●
not properly engaged nobody else can travel  
in the corresponding seats (not even a child).  
●
Raise and lock in the back rest. The red  
Adjust the headrest so that its upper edge is  
at the same level as the top of your head and  
under no circumstances below eye level. Keep  
the back of your head always as close to the  
head restraint as possible.  
2
marking on button  
ble when the backrest is properly secured.  
should no longer be visi-  
NOTICE  
WARNING  
Serious damage can be caused to the vehicle  
and other objects if the rear seat backrest is  
lowered or lifted without due care and atten-  
tion.  
Serious injuries can be caused if the rear seat  
backrest is lowered or lifted without due care  
and attention.  
Adjusting the head restraint for short people  
1)  
●
Before lowering the rear seat backrest, al-  
●
Never lower or lift the rear seat backrest  
Lower the head restraint completely, even if  
your head is below its upper edge. In the low-  
est position, there may be a small distance be-  
tween the head restraint and the backrest.  
ways adjust the front seats so that neither  
the head restraints nor the cushions of the  
rear backrest can hit them.  
while driving.  
●
Do no trap or damage the seat belt when  
raising the rear seat backrest.  
●
When lowering or lifting the rear seat back-  
rest, keep your hands, ꢁngers, feet and other  
body parts out of its path.  
Adjusting the head restraint for tall people1)  
Headrest  
Push the head restraint up as far as it will go.  
●
For the rear seat belts to oꢀer the nec-  
Introduction  
essary protection all the parts of the rear  
backrest must be properly engaged. This is  
particularly important in the case of the cen-  
tre rear seat. If someone is seated in a seat  
whose backrest is not properly engaged they  
will ꢂy forward, along with the backrest, dur-  
ing an accident or a sudden driving or brak-  
ing manoeuvre.  
WARNING  
The possibilities for the adjustment and disas-  
sembly of the headrests are described below.  
Always make sure that the seats are correctly  
adjusted ››› page 39.  
All seats are equipped with a head restraint.  
The central rear headrest is only intended for  
the central seat of the rear bench. Therefore,  
do not install it on any other seat.  
If travelling with the head restraints removed  
or improperly adjusted, the risk of severe or  
fatal injuries in the event of accidents and  
sudden braking or manoeuvres increases.  
●
Always travel with the head restraint cor-  
rectly installed and adjusted.  
●
2
A red mark on button  
warns that the  
●
To decrease the risk of cervical injuries in  
rear backrest is not engaged. Always check  
that the red marking is not visible when the  
backrest is in the upright position.  
the event of an accident, adjust the head  
restraint correctly based on your height, al-  
ways making sure that its upper edge is at  
the same height as the top of the head, but  
1)  
On seats with adjustable headrests.  
109  
Seats and head restraints  
Adjusting the height of the head restraints  
●
1
Press button ››› Fig. 99 , while simultane-  
never below eye level. Keep the back of your  
head always as close to the head restraint as  
possible and centred.  
2
ously pressing on the safety hole  
screwdriver a maximum of 5 mm wide, and re-  
move the headrest.  
with a ꢀat  
●
Grab the sides of the head restraints with  
both hands and push upwards to the desired  
●
Never adjust the head restraint while the  
position. To lower it, repeat the same action,  
vehicle is in motion.  
●
Move the backrest until it engages properly  
1
pressing the button on the side ››› Fig. 98.  
●
››› in Folding down and raising the rear  
Under no circumstances should the rear  
●
The headrest must lock correctly in one po-  
passengers travel while the head restraints  
are in the non-use position.  
seat backrest on page 109.  
sition.  
Fitting the rear head restraints  
Removing and ꢁtting the headrests  
NOTICE  
To mount the external head restraints, the cor-  
responding backrest must be partially folded  
forward.  
When assembling and disassembling the  
head restraints, do not let them meet the  
top lining of the vehicle, the back rest of the  
front seat or other parts of the vehicles. If  
not, this could damage the vehicle.  
●
Unlock the backrest ››› page 108.  
●
Insert the head restraint bars into the guides  
until they perceptibly engage. It should not be  
possible to remove the head restraint from the  
backrest.  
Adjusting the headrests  
●
Move the backrest until it engages properly  
››› in Folding down and raising the rear  
seat backrest on page 109.  
Fig. 99 Rear head restraint: removal.  
WARNING  
Removing the rear head restraints  
Remove the rear headrests only when it is  
necessary to ꢁt a child seat. After removing a  
child seat, reꢁt the headrest immediately.  
To remove the head restraint, the correspond-  
ing backrest must be partially folded forward.  
●
Unlock the backrest ››› page 108.  
Move the head restraint upwards until it ar-  
●
rives to the top.  
Fig. 98 Rear headrest: adjusting the  
headrest.  
110  
Seat functions
●
Never let anyone sit on the centre arm-  
WARNING  
Seat functions  
rest while the vehicle is in motion, not even  
a child. This position is incorrect and may  
cause severe injuries.  
To decrease the risk of injuries while driv-  
ing, the rear centre armrest must always be  
raised.  
Front centre armrest  
●
When the centre armrest is down, nobody  
may travel in the centre rear seat, not even a  
child. An incorrect sitting position may cause  
severe injuries.  
Rear centre armrest  
Massage function  
Fig. 100 Front centre armrest  
To raise the armrest, pull it fully up in the direc-  
tion of the arrow ››› Fig. 100 up or step by  
step depending on the desired opening.  
Fig. 101 Folding rear centre armrest  
(schematic view).  
To lower the armrest, ꢁrst lift it to its highest  
position. Then lower it down.  
There might be a folding armrest in the rear  
centre seat.  
Fig. 102 On the lateral underside of  
the driver and passenger seats: massage  
function button.  
●
To lower the armrest, pull the cord in the  
WARNING  
direction of the arrow ››› Fig. 101.  
●
site direction to the arrow and press it as far as  
it will go into the seat backrest.  
The front centre armrest may obstruct the  
driver's arm movements, which could cause  
an accident and severe injuries.  
To raise the armrest, push it up in the oppo-  
When the function is activated, the lumbar  
support moves to massage the lumbar area of  
the back.  
●
Keep the storage compartments of the  
centre armrest closed at all times while the  
vehicle is in motion.  
When the centre armrest is down, do not allow  
anybody to travel in the centre seat of the rear  
bench.  
111  
Seats and head restraints  
Activating and deactivating the massage  
function  
To activate the function, press the button on  
the seat control panel. To deactivate it, press  
the button again.  
The function automatically deactivates after  
approx. 10 minutes.  
WARNING  
Improper use of the seat functions can result  
in serious injury.  
●
Before setting oꢀ, always adopt the correct  
position and keep it throughout the journey.  
This point applies to all occupants of the ve-  
hicle.  
●
Only activate and deactivate the massage  
function when the vehicle is stationary.  
●
Always keep your hands, ꢁngers, feet and  
other body parts away from the seat operat-  
ing and adjustment areas.  
112  

Related Topics

Popular Owner Manuals