2002-2008 Cupra Born SUV Seats and head restraints -> Headrest User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats and head restraints -> Headrest for Your Cupra Born SUV First Generation (2002-2008)

Headrest
When the rear seat backrest is lowered or is  
Correct adjustment of head restraint1)  
Converting the table to a seat  
●
not properly engaged nobody else can travel  
in the corresponding seats (not even a child).  
●
Raise and lock in the back rest. The red  
Adjust the headrest so that its upper edge is  
at the same level as the top of your head and  
under no circumstances below eye level. Keep  
the back of your head always as close to the  
head restraint as possible.  
2
marking on button  
ble when the backrest is properly secured.  
should no longer be visi-  
NOTICE  
WARNING  
Serious damage can be caused to the vehicle  
and other objects if the rear seat backrest is  
lowered or lifted without due care and atten-  
tion.  
Serious injuries can be caused if the rear seat  
backrest is lowered or lifted without due care  
and attention.  
Adjusting the head restraint for short people  
1)  
●
Before lowering the rear seat backrest, al-  
●
Never lower or lift the rear seat backrest  
Lower the head restraint completely, even if  
your head is below its upper edge. In the low-  
est position, there may be a small distance be-  
tween the head restraint and the backrest.  
ways adjust the front seats so that neither  
the head restraints nor the cushions of the  
rear backrest can hit them.  
while driving.  
●
Do no trap or damage the seat belt when  
raising the rear seat backrest.  
●
When lowering or lifting the rear seat back-  
rest, keep your hands, ꢀngers, feet and other  
body parts out of its path.  
Adjusting the head restraint for tall people1)  
Headrest  
Push the head restraint up as far as it will go.  
●
For the rear seat belts to oꢁer the nec-  
Introduction  
essary protection all the parts of the rear  
backrest must be properly engaged. This is  
particularly important in the case of the cen-  
tre rear seat. If someone is seated in a seat  
whose backrest is not properly engaged they  
will ꢂy forward, along with the backrest, dur-  
ing an accident or a sudden driving or brak-  
ing manoeuvre.  
WARNING  
The possibilities for the adjustment and disas-  
sembly of the headrests are described below.  
Always make sure that the seats are correctly  
adjusted ››› page 39.  
All seats are equipped with a head restraint.  
The central rear headrest is only intended for  
the central seat of the rear bench. Therefore,  
do not install it on any other seat.  
If travelling with the head restraints removed  
or improperly adjusted, the risk of severe or  
fatal injuries in the event of accidents and  
sudden braking or manoeuvres increases.  
●
Always travel with the head restraint cor-  
rectly installed and adjusted.  
●
2
A red mark on button  
warns that the  
●
To decrease the risk of cervical injuries in  
rear backrest is not engaged. Always check  
that the red marking is not visible when the  
backrest is in the upright position.  
the event of an accident, adjust the head  
restraint correctly based on your height, al-  
ways making sure that its upper edge is at  
the same height as the top of the head, but  
1)  
On seats with adjustable headrests.  
109  
Seats and head restraints  
Adjusting the height of the head restraints  
●
1
Press button ››› Fig. 99 , while simultane-  
never below eye level. Keep the back of your  
head always as close to the head restraint as  
possible and centred.  
2
ously pressing on the safety hole  
screwdriver a maximum of 5 mm wide, and re-  
move the headrest.  
with a ꢀat  
●
Grab the sides of the head restraints with  
both hands and push upwards to the desired  
●
Never adjust the head restraint while the  
position. To lower it, repeat the same action,  
vehicle is in motion.  
●
Move the backrest until it engages properly  
1
pressing the button on the side ››› Fig. 98.  
●
››› in Folding down and raising the rear  
Under no circumstances should the rear  
●
The headrest must lock correctly in one po-  
passengers travel while the head restraints  
are in the non-use position.  
seat backrest on page 109.  
sition.  
Fitting the rear head restraints  
Removing and ꢀtting the headrests  
NOTICE  
To mount the external head restraints, the cor-  
responding backrest must be partially folded  
forward.  
When assembling and disassembling the  
head restraints, do not let them meet the  
top lining of the vehicle, the back rest of the  
front seat or other parts of the vehicles. If  
not, this could damage the vehicle.  
●
Unlock the backrest ››› page 108.  
●
Insert the head restraint bars into the guides  
until they perceptibly engage. It should not be  
possible to remove the head restraint from the  
backrest.  
Adjusting the headrests  
●
Move the backrest until it engages properly  
››› in Folding down and raising the rear  
seat backrest on page 109.  
Fig. 99 Rear head restraint: removal.  
WARNING  
Removing the rear head restraints  
Remove the rear headrests only when it is  
necessary to ꢀt a child seat. After removing a  
child seat, reꢀt the headrest immediately.  
To remove the head restraint, the correspond-  
ing backrest must be partially folded forward.  
●
Unlock the backrest ››› page 108.  
Move the head restraint upwards until it ar-  
●
rives to the top.  
Fig. 98 Rear headrest: adjusting the  
headrest.  
110  

Related Topics

Popular Owner Manuals