19
01
Instruments
lighting of the Service warning lamp and an
audible signal.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to avoid
damage to the engine.
Engine coolant temperature
indicator
AdBlue® range indicators
(BlueHDi)
The Diesel BlueHDi engines are equipped with
a system that associates the SCR (Selective
Catalytic Reduction) emissions control system
and the Diesel particle filter (DPF) for the
treatment of exhaust gases. They cannot function
without AdBlue® fluid.
For more information on Checking levels, refer to
the corresponding section.
Oil level indicator fault
This is indicated by the display of the message
"Oil level measurement invalid" on the instrument
panel.
When the level of AdBlue® falls below the reserve
level (between 1,500 and 0 miles (2,400 and
0 km)), a warning lamp lights up when the ignition
is switched on and an estimate of the distance
that can be travelled before engine starting is
prevented is displayed in the instrument panel.
Contact a dealer or a qualified workshop.
In the event of a fault with the electric
indicator, the oil level is no longer
monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located under the bonnet.
With the engine running:
– In zone A, the temperature is correct.
– In zone B, the temperature is too high; the
associated warning lamp and the central STOP
warning lamp come on in red on the instrument
panel, accompanied by the display of a message
and an audible signal.
The engine starting prevention system
required by regulations is activated
automatically once the AdBlue® tank is empty.
It is then no longer possible to start the engine
until the minimum level of AdBlue® has been
topped up.
For more information on Checking levels, refer
to the corresponding section.
You must stop the vehicle as soon as it is safe to
do so.
Wait a few minutes before switching off the
engine.
Manually displaying the driving range
While the driving range is greater than 1,500 miles
(2,400 km), it is not displayed automatically.
You can view the range information by
pressing the "Check / Diagnostic" button
in the touch screen’s Driving / Vehicle menu.
After switching off the ignition, carefully
open the bonnet and check the coolant
level.
For more information on Checking levels,
refer to the corresponding section.
English 
