22
01
Instruments
When travelling abroad, you may have to
WithDS CONNECT NAV
In all other display modes, pressing the end of the
wiper control stalk causes this data to appear
temporarily in a specific window.
change the distance units (km or miles):
the road speed must be displayed in the local
country’s official unit (km/h or mph).
The unit is changed via the screen
configuration menu, with the vehicle
stationary.
►ꢀ Press this button to select the Settings
menu.
►ꢀ Select "OPTIONS".
Display of the different tabs
►ꢀ Select "Screen configuration".
►ꢀ Select the "Brightness" tab.
►ꢀ Adjust the brightness by pressing the
arrows or moving the slider.
Lighting dimmer
This system allows the brightness of the
instruments and controls to be adjusted to suit
the ambient light level.
►ꢀ Press this button to save and exit.
You can also switch off the screen:
►ꢀ Press this button to select the Settings
menu.
►ꢀ Press this button located on the end of the
wiper control stalk to display the different tabs
in turn:
With DS CONNECT RADIO
►ꢀ Select "Turn off screen".
►ꢀ Press this button to select the Settings
menu.
►ꢀ Select "Brightness".
– Current information:
The screen goes off completely.
►ꢀ Press the screen again (anywhere on its
surface) to activate it.
• Total range (petrol or Diesel).
• Total range (petrol or Diesel).
• Stop & Start time counter (petrol or Diesel).
• Percentage of the current journey travelled in
all-electric driving mode (Hybrid).
– Trips "1" then "2":
• Average speed.
• Average fuel consumption.
• Distance travelled.
►ꢀ Adjust the brightness by pressing the
arrows or moving the slider.
Trip computer
Information displayed about the current journey
(range, fuel consumption, average speed, etc.).
The settings are applied immediately.
►ꢀ Press outside the settings window to exit.
You can also switch off the screen:
►ꢀ Press this button to select the Settings
menu.
Display of data in the
instrument panel
Trip computer data is displayed permanently
when the "TRIP COMPUTER" or "PERSONAL"
display mode is selected, depending on version.
►ꢀ Select "Dark".
Trip reset
The screen goes off completely.
►ꢀ Press the screen again (anywhere on its
surface) to activate it.
►ꢀ When the desired trip is displayed,
press the button on the end of the wiper
control stalk for more than 2 seconds.
Trips "1" and "2" are independent and are used
identically.
English 
