Practical information -> Roof bars for Your DS 7 Crossback 4 Door First Generation (2017-2022)

166  
07  
Practical information  
It consists of a first element for the upper part  
of the front grille and a second element for the  
lower part.  
Avoid driving with snow chains on roads  
that have been cleared of snow to avoid  
damaging the vehicle's tyres and the road  
surface. If the vehicle is fitted with alloy  
wheels, check that no part of the chain or its  
fixings is in contact with the wheel rim.  
Original tyre size  
215/65 R17  
Maximum link size  
9 mm  
For fitting / removing, contact a dealer or  
a qualified workshop.  
235/55 R18  
9 mm  
235/50 R19  
cannot be fitted with  
chains  
Before any operation, ensure that the  
engine is off and the cooling fan has  
stopped.  
Hybrid vehicles  
The use of snow chains is only authorised  
on the front wheels.  
The driving mode selector must be on the 4WD  
position (depending on version).  
205/55 R19  
235/45 R20  
9 mm  
cannot be fitted with  
chains  
It is essential to remove them when:  
– the exterior temperature exceeds 10°C.  
– towing.  
For more information on snow chains, contact a  
dealer or a qualified workshop.  
– the speed is above 75 mph (120 km/h).  
Installation tips  
Roof bars  
►ꢀ To fit the chains during a journey, stop the  
vehicle on a flat surface on the side of the road.  
►ꢀ Apply the parking brake and position any  
wheel chocks under the wheels to prevent  
movement of the vehicle.  
As a safety measure and to avoid  
damaging the roof, it is essential to use  
the transverse bars approved for the vehicle.  
Observe the instructions on fitting and use  
contained in the guide supplied with the roof  
bars.  
Snow chains  
In wintry conditions, snow chains improve  
traction as well as the behaviour of the vehicle  
when braking.  
►ꢀ Fit the chains following the instructions  
provided by the manufacturer.  
►ꢀ Move off gently and drive for a few moments,  
without exceeding 31 mph (50 km/h).  
►ꢀ Stop the vehicle and check that the snow  
chains are correctly tightened.  
The snow chains must be fitted only to  
the front wheels. They must never be  
fitted to "space-saver" type spare wheels.  
Maximum authorised load distributed  
over the transverse roof bars, for a  
loading height not exceeding 40 cm (with the  
exception of bicycle carriers): 80 kg.  
As this value may change, please verify the  
maximum load set out in the manual supplied  
with the roof bars.  
Take account of the legislation specific to  
each country on the use of snow chains  
and the maximum authorised speed.  
It is strongly recommended that before  
you leave, you practise fitting the snow  
chains on a level and dry surface.  
Use only the chains designed to be fitted to the  
type of wheel fitted to the vehicle:  
167  
07  
Practical information  
If the height exceeds 40 cm, adapt the speed  
of the vehicle to the profile of the road to avoid  
damaging the roof bars and the fixings on the  
vehicle.  
Be sure to refer to national legislation in order  
to comply with the regulations for transporting  
objects which are longer than the vehicle.  
Regularly check the security and tight  
Fitting directly to the roof  
fastening of the roof bars, at least before each  
trip.  
Remove the roof bars once they are no longer  
needed.  
Bonnet  
Fitting on longitudinal bars  
Stop & Start  
Before doing anything under the bonnet,  
you must switch off the ignition to avoid any  
risk of injury resulting from an automatic  
change to START mode.  
You must only attach the transverse bars to the  
four fixing points located on the roof frame. These  
points are concealed by the vehicle doors when  
the doors are closed.  
The roof bar fixings have a stud which must be  
inserted into the opening of each fixing point.  
Hybrid vehicles  
The transverse bars must be fixed at the engraved  
markings on the longitudinal bars.  
Before any work is carried out under the  
bonnet, it is essential to switch off the ignition  
and check that the READY indicator lamp is off  
in the instrument panel - risk of serious injury!  
Recommendations  
Distribute the load uniformly, taking care  
to avoid overloading one of the sides.  
Arrange the heaviest part of the load as close  
as possible to the roof.  
The location of the interior bonnet release  
lever prevents the bonnet being opened  
when the left-hand front door is closed.  
Secure the load firmly.  
Drive gently: the vehicle will be more  
susceptible to the effects of side winds and its  
stability may be affected.