2020-2024 DS 9 4 Door Lighting and visibility -> Automatic headlamp dipping User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Lighting and visibility -> Automatic headlamp dipping for Your DS 9 4 Door First Generation (2020-2024)

64  
04  
Lighting and visibility  
Operating limits  
The system becomes operational when  
the vehicle exceeds 16 mph (25 km/h).  
When the speed falls below 9 mph (15 km/h),  
the function is no longer operational.  
Automatic headlamp  
dipping  
The system may be disrupted or not work  
correctly:  
– When visibility conditions are poor  
(e.g. snowfall, heavy rain).  
For more information, refer to the General  
recommendations for automatic lighting  
systems.  
– If the windscreen is dirty, misted-up or  
masked (e.g. sticker) in front of the camera.  
– If the vehicle is facing highly reflective signs  
or safety barrier reflectors.  
Activation/Deactivation  
It is set via the Driving / Vehicle touch  
With the ring of the lighting control stalk in the  
"AUTO" position and the function activated on the  
touch screen, this system automatically switches  
between dipped and main beam headlamps,  
according to lighting and traffic conditions, using  
a camera located at the top of the windscreen.  
screen menu.  
The state of the system stays in the memory when  
switching off the ignition.  
The system is not able to detect:  
– Road users that do not have their own  
lighting, such as pedestrians.  
Operation  
If the ambient light level is very low and traffic  
– Vehicles with hidden lighting (e.g. travelling  
behind a safety barrier on the motorway).  
– Vehicles at the top or bottom of a steep  
slope, on winding roads, on crossroads.  
conditions permit:  
– The main beam headlamps come  
on automatically. These indicator  
lamps light up on the instrument panel.  
If the ambient light level is sufficient and/or the  
traffic conditions do not allow the main beam  
headlamps to be lit:  
Maintenance  
Clean the windscreen regularly,  
particularly the area in front of the camera.  
The internal surface of the windscreen can  
also become misted around the camera.  
In humid and cold weather, demist the  
windscreen regularly.  
– The dipped beam headlamps  
remain lit. These indicator lamps  
light up on the instrument panel.  
The function is deactivated if the foglamps are  
switched on or if the system detects poor visibility  
conditions (e.g. fog, heavy rain, snowfall).  
When the foglamps are switched off or when the  
visibility conditions become favourable again, the  
function is automatically reactivated.  
This indicator lamp goes out when the  
function is deactivated.  
Do not allow snow to accumulate on the  
bonnet or roof of the vehicle as this could  
obstruct the camera.  
This system is a driving aid.  
The driver remains responsible for  
the vehicle's lighting, its correct use in the  
prevailing light, visibility and traffic conditions,  
and for compliance with driving and vehicle  
regulations.  
65  
04  
Lighting and visibility  
The modules rotate and tilt so as to expand and  
direct the light beam to increase or decrease the  
lighting up of the sides of the road.  
The width of the beam is increased to allow you to  
better distinguish hazards on the side of the road  
(pedestrians, intersections).  
Pause  
If the situation requires a change of headlamp  
beam, the driver can take over at any time.  
►ꢀ Switch the headlamps manually between  
dipped and main beam to pause the function.  
If the "AUTO" and "Dipped beam" indicator lamps  
were on, the system changes to main beam.  
If the "AUTO" and "Main beam" indicator lamps  
were on, the system changes to dipped beam.  
►ꢀ To reactivate the function, once again switch  
the headlamps manually between dipped and  
main beam.  
The range of this lighting is approximately 230 m.  
This mode is activated once the vehicle has  
been moving for more than 3 seconds at a speed  
between 0 and 31 mph (50 km/h).  
This function is a driving aid which  
cannot, in any circumstances, replace the  
need for vigilance on the part of the driver who  
must continually adapt the driving of the  
vehicle to the visibility and traffic conditions.  
"Road" mode  
Activation/Deactivation  
►ꢀ Place the ring of the lighting control stalk in  
the "AUTO" position.  
Malfunction  
►ꢀ In the Driving/Vehicle touch screen  
menu, select "Adaptive lighting".  
If a malfunction occurs with the system or  
the camera, this warning lamp lights up on  
the instrument panel, accompanied by an audible  
signal and a message.  
Operation  
"City" mode  
This lighting provides a higher light beam, an  
increased intensity of the headlamps and a  
decreased intensity of the modules.  
Have it checked by a dealer or a qualified  
workshop.  
The range of this lighting is approximately 240 m.  
This mode is activated once the vehicle has  
been moving for more than 2 seconds at a speed  
between 31 and 68 mph (50 and 110 km/h).  
Adaptive Frontlight  
System  
Available only on versions equipped with DS  
ACTIVE LED VISION headlamps.  
This function has several lighting modes, specific  
to each driving situation.  
The headlamps provide medium-intensity  
illumination supplemented by the modules facing  
outwards.  
The intensity and direction of the main headlamps  
and the modules vary so as to increase or reduce  
the range of the lighting.  

Related Topics

Popular Owner Manuals