69
04
Lighting and visibility
In the event of a malfunction, this warning
lamp lights up on the instrument panel,
accompanied by the display of a message and an
audible signal.
operate the control stalk again to reactivate
Windscreen wipers
wiping when the ignition is switched on again
(unless the ignition was off for less than
a minute).
The system places the headlamp beams in the
lowest position.
After the ignition has been switched off,
the wipers may move slightly at the foot
of the windscreen.
Have it checked by a dealer or a qualified
workshop.
Do not touch the "Full LED" technology
headlamps - risk of electrocution!
Single wipe
►ꢀ To select the wiping speed: raise or lower the
stalk to the desired position.
►ꢀ Pull the stalk briefly towards you.
Fast wiping (heavy rain)
Wiper control stalk
Windscreen wash
►ꢀ Pull the wiper control stalk towards you and
Normal wiping (moderate rain)
Before operating the wipers in wintry
conditions, clear any snow, ice or frost
from the windscreen and around the wiper
arms and blades.
hold.
A final wiping cycle is performed when
screenwashing ends.
Intermittent wiping (proportional to the
vehicle’s speed)
Switching off
The windscreen wash jets are
incorporated into the tip of each wiper
arm.
Do not operate the wipers on a dry
windscreen. In extremely hot or cold
weather, check that the wiper blades are not
stuck to the windscreen before operating the
wipers.
Automatic wiping
Screenwash fluid is sprayed along the length
of the wiper blade. This improves visibility and
reduces screenwash fluid consumption.
Refer to the corresponding section.
In position 1 or 2, the wiping frequency is
automatically reduced when the speed of
the vehicle drops below 3 mph (5 km/h).
When the speed is above 6 mph (10 km/h)
again, the wiping frequency returns to the
original frequency (fast or normal).
To avoid damaging the wiper blades, do
not operate the screenwash if the
After using an automatic car wash, you
may temporarily notice abnormal noises
and poorer wiping performance. You do not
need to replace the wiper blades.
screenwash reservoir is empty.
Only operate the screenwash if there is no risk
of the fluid freezing on the windscreen and
hindering visibility. During the winter period,
use "very cold climate" rated products.
If the ignition has been switched off with
the windscreen wipers active, you must
English 
