78
Safety
05
remain on as long as the front seatbelts are not
fastened.
To ensure the proper functioning of the belt
buckles, make sure that there are no foreign
bodies present (e.g. a coin) before fastening.
Before and after use, ensure that the seat belt
is reeled in correctly.
Seat belt not fastened/
unfastened alerts
Not fastened at the rear (depending on
version)
When the ignition is switched on, with the engine
running or the vehicle moving at a speed below
12 mph (20 km/h), the warning lamp and the
corresponding indicator lamps light up for around
sixty seconds, if one or more rear seat belts are
not fastened.
After folding or moving a seat or rear bench
seat, ensure that the seat belt is positioned
and reeled in correctly.
Installation
The lower part of the strap must be
positioned as low as possible over the pelvis.
The upper part must be positioned in the
hollow of the shoulder.
Unfastened
After the ignition is switched on, the warning
lamp and the corresponding indicator lamps light
up if the driver and/or one or more passengers
unfasten their seat belts.
Not fastened/unfastened warning lamp
It comes on in red on both the instrument panel
and the front passenger airbag and seat belts
warning lamps display, once the system detects
that a seat belt is not fastened or has been
unfastened.
At the front, adjusting the position of the
seat belt may require the seat height to be
adjusted.
At a speed greater than 12 mph (20 km/h), these
warning lamps flash, accompanied by an audible
signal for approximately two minutes. After this
time, these warning lamps remain on as long as
the seatbelts are not refastened.
In order to be effective, a seat belt must:
– be tightened as close to the body as
possible.
Seat belts not fastened/unfastened identification
indicator lamp
– be pulled in front of you with a smooth
movement, checking that it is not twisted.
– must only be used to secure one person.
– not show signs of tearing or fraying.
– not be changed or modified, in order to avoid
affecting its performance.
The red indicator lamps on the display indicate
the location of the seat belts which are not
fastened or have been unfastened.
Advice
Not fastened
The driver must ensure that passengers
use the seat belts correctly and that they
are all fastened before setting off.
Wherever seated in the vehicle, you must
always fasten the seat belt, even for short
journeys.
When the ignition is switched on, the warning
lamp and the corresponding indicator lamps light
up if the driver and/or one of the passengers have
not fastened their seat belt.
Recommendations for children
Use a suitable child seat if the passenger
is less than 12 years old or shorter than 1.5
metres.
At a speed greater than 12 mph (20 km/h),
these warning lamps flash, accompanied by an
increasing audible signal for approximately two
minutes. After two minutes, these warning lamps
Do not invert the seat belt buckles, as they will
not fulfil their role properly.